Flight Instructor for Airplane Category › VII. Takeoffs, Landings, and Go-Arounds › Task D. Soft-Field Approach and Landing (ASEL)

AI.VII.D.S6

Skill

Establish the recommended approach and landing configuration, airspeed, and trim, and adjust pitch attitude and power as required to maintain a stabilized approach.

Practice questions Ask the tutor

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Airplane Flying Handbook p. 9-26
Chapter 9: Approaches and Landings › Power-Off Accuracy Approaches › 180° Power-Off Approach
Full flaps should be delayed until it is clear that adding them will not cause the landing to be short of the point. The pilot should never try to stretch the glide or retract the flaps to reach the desired ... landing spot. On short final, full attention is given to making a good, safe landing rather than concentrating on the selected landing spot. The approach angle used and final approach airspeed determine the probability of landing on the spot…
Airplane Flying Handbook p. 9-3
Chapter 9: Approaches and Landings › Normal Approach and Landing › Final Approach
drift correction is established and maintained to follow a ground track perpendicular to the extension of the landing runway centerline. This requires that the airplane be angled sufficiently into the wind to prevent drifting farther away from the intended landing ... spot. Figure 9-3. Base leg and final approach. Final Approach After the base-to-final approach turn is completed, the pilot aligns the longitudinal axis of the airplane with the centerline of the runway or landing surface…
Airplane Flying Handbook p. 9-20
Chapter 9: Approaches and Landings › Turbulent Air Approach and Landing
Attempted landing in crosswinds that exceed the airplane’s maximum demonstrated crosswind component. 2. Undershooting or overshooting the turn from base leg to final approach. 3. Inadequate compensation for wind drift on final approach. 4. Unstable approach. 5. Excessive sink ... rate or too low an airspeed from increased drag and reduced vertical lift during sideslip. 6. Failure to touch down with the longitudinal axis aligned with the runway. 7. Touching down while drifting. 8. Excessive airspeed on touchdown. 9. Failure…
Airplane Flying Handbook p. 9-22
Chapter 9: Approaches and Landings › Short-Field Approach and Landing
Figure 9-23. Unstabilized approach. After the landing gear has been extended, if applicable, or when beginning a suitable final approach, the pilot simultaneously adjusts the power and the pitch attitude to establish and maintain the proper descent angle ... airspeed. During a stabilized approach, small changes in the airplane’s pitch attitude and power setting are needed when making corrections to the angle of descent and airspeed. The short-field approach and landing is an accuracy approach…