AI.VII.E.K1

From the FAA library

• Airplane Flying Handbookp. 6-11
  Chapter 6: Takeoffs and Departure Climbs › Short-Field Takeoff and Maximum Performance Climb

  pilot should reduce AOA to attain normal airspeed before attempting to fly out of the ground effect areas. Short-Field Takeoff and Maximum Performance Climb When performing takeoffs and climbs from fields where the takeoff area is short ... available takeoff area is restricted by obstructions, the pilot should operate the airplane at the maximum limit of its takeoff performance capabilities. To depart from such an area safely, the pilot needs to exercise positive and precise control of airplane…

• Airplane Flying Handbookp. 13-17
  Chapter 13: Transition to Multiengine Airplanes › Short-Field Takeoff and Climb

  Short-Field Takeoff and Climb The short-field takeoff and climb differs from the normal takeoff and climb in the airspeeds and initial climb profile. Some AFM/POHs give separate short-field takeoff procedures and performance charts that recommend specific flap ... settings and airspeeds. Other AFM/POHs do not provide separate short-field procedures. In the absence of such specific procedures, the airplane should be operated only as recommended in the AFM/POH. No operations should be conducted contrary to the recommendations…

• Airplane Flying Handbookp. 6-11
  Chapter 6: Takeoffs and Departure Climbs › Short-Field Takeoff and Maximum Performance Climb › Takeoff Roll

  Takeoff Roll Taking off from a short field requires the takeoff to be started from the very beginning of the takeoff area. At this point, the airplane is aligned with the intended takeoff path. If the airplane manufacturer recommends ... flaps, they are extended the proper amount before beginning the takeoff roll. This allows the pilot to devote full attention to the proper technique and the airplane’s performance throughout the takeoff. The pilot should apply takeoff power smoothly…

• Pilot's Handbook of Aeronautical Knowledgep. 11-6
  Chapter 11: Aircraft Performance › Performance › Climb Performance

  Positive climb performance occurs when an aircraft gains PE by increasing altitude. Two basic factors, or a combination of the two factors, contribute to positive climb performance in most aircraft: 1. The aircraft climbs (gains PE) using excess power above ... that required to maintain level flight, or 2. The aircraft climbs by converting airspeed (KE) to altitude (PE). As an example of factor 1 above, an aircraft with an engine capable of producing 200 horsepower (at a given altitude…

• Airplane Flying Handbookp. 6-12
  Chapter 6: Takeoffs and Departure Climbs › Short-Field Takeoff and Maximum Performance Climb › Initial Climb

  pressure on the nose-wheel and may result in “wheel barrowing.” It also hinders both acceleration and overall airplane performance. Initial Climb On short-field takeoffs, the landing gear and flaps should remain in takeoff position until the airplane ... sudden loss of lift and settling of the airplane. The pilot should next reduce the power to the normal climb setting or as recommended by the airplane manufacturer. Common errors in the performance of short-field takeoffs and maximum performance…

• Pilot's Handbook of Aeronautical Knowledgep. 11-15
  Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance

  Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…