Flight Instructor for Airplane Category › VII. Takeoffs, Landings, and Go-Arounds › Task G. Confined Area Takeoff and Maximum Performance Climb (ASES, AMES)

AI.VII.G.S14

Skill

Retract flaps, if extended, after a positive rate of climb has been verified or in accordance with airplane manufacturer’s guidance.

Practice questions Ask the tutor

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Airplane Flying Handbook p. 3-17
Chapter 3: Basic Flight Maneuvers › Climbs and Climbing Turns
Normal climb speed is generally higher than the airplane’s best rate of climb. The additional airspeed provides for better engine cooling, greater control authority, and better visibility over the nose of the airplane. Normal climb is sometimes referred ... cruise climb. ⦁ Best rate of climb (VY)—produces the most altitude gained over a given amount of time. This airspeed is typically used when initially departing a runway without obstructions until it is safe to transition to a normal…
Airplane Flying Handbook p. 6-12
Chapter 6: Takeoffs and Departure Climbs › Short-Field Takeoff and Maximum Performance Climb › Initial Climb
rotate to the appropriate pitch attitude at (or near) VX. The pilot should be aware that some airplanes have a natural tendency to lift off well before reaching VX. In these airplanes, it may be necessary to allow the airplane ... lift off in ground effect and then reduce pitch attitude to level until the airplane accelerates to VX with the wheels just clear of the runway surface. This method is preferable to forcing the airplane to remain on the ground…
Airplane Flying Handbook p. 16-17
Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Initial Climb
Initial Climb Once the proper pitch attitude is attained, the pilot should maintain it. Takeoff power is also maintained and the airspeed allowed to accelerate. Landing gear retraction should be accomplished after a positive rate of climb has been established ... confirmed. In some airplanes gear retraction may temporarily increase the airplane drag while landing gear doors open. Premature gear retraction may cause the airplane to settle back toward the runway surface. In addition, the vertical speed indicator and the altimeter…
Airplane Flying Handbook p. 6-13
Chapter 6: Takeoffs and Departure Climbs › Soft/Rough-Field Takeoff and Climb › Initial Climb
Initial Climb After a positive rate of climb is established, and the airplane has accelerated to VY, the pilot should retract the landing gear and flaps, if equipped. If departing from an airstrip with wet snow or slush ... takeoff surface, the gear should not be retracted immediately so that any wet snow or slush can be air-dried. In the event an obstacle needs to be cleared after a soft-field takeoff, the pilot should perform the climb…