AI.VII.H.R3
Risk managementPlanning for a go-around and rejected landing.
From the FAA library
- LANDINGS
LANDINGS Landing a skiplane is easy compared to landing with wheels; however, for off-airport landings, extra precautions are necessary. Be careful in choosing a landing site. Before landing, evaluate the site to be sure a safe departure will ... possible. Upon arriving at a prospective landing site, a pass should be made over the landing area to determine landing direction, and to determine if a safe approach and landing can be completed. A trial landing should be accomplished…
- Chapter 9: Approaches and Landings › Go-Arounds (Rejected Landings)
Arounds (Rejected Landings) A go-around is a normal maneuver that is used when approach and landing parameters deviate from expectations or when it is hazardous to continue. Situations such as air traffic control (ATC) requirements, unexpected appearance of hazards ... overtaking another airplane, wind shear, wake turbulence, mechanical failure, or an unstable approach are all reasons to discontinue a landing approach. Like any other normal maneuver, the go-around should be practiced and perfected. The flight instructor should emphasize early…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance
item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…
- LANDING › EMERGENCY LANDING
AROUND Whenever landing conditions are not satisfactory, execute a go-around. Potential conflicts with other aircraft, surface vessels or swimmers in the landing area, recognition of a hazard on the water, wind shear, wake turbulence, water surface conditions, mechanical failure ... unstabilized landing approach are a few of the reasons to discontinue a landing attempt. Climb to a safe altitude while executing the go-around checklist, then evaluate the situation, and make another approach under more favorable conditions. Remember that…
- Chapter 5. Air Traffic Procedures › Section 1. Preflight › 5-1-5. Flight Plan - VFR Flights
Flight Plan - VFR Flights (See Appendix 4, FAA Form 7233-4 – International Flight Plan) a. The requirements for the filing and activation of VFR flight plans can vary depending in which airspace the flight is operating. Pilots are responsible ... activating flight plans with a Flight Service Station. Control tower personnel do not automatically activate VFR flight plans. 1. Within the continental U.S., a VFR flight plan is not normally required. 2. VFR flights (except for DoD and law enforcement…
- LANDING AREA RECONNAISSANCE AND PLANNING
other waves cancel each other out, leaving smoother areas. Often it is possible to avoid the larger waves and land on the smooth areas. In seaplanes equipped with retractable landing gear (amphibians), it is extremely important to make certain that ... wheels are retracted when landing on water. Wherever possible, make a visual check of the wheels themselves, in addition to checking the landing gear position indicators. A wheels-down landing on water is almost certain to capsize the seaplane…