AI.VII.N.R8
Risk managementManaging a go-around/rejected landing after accepting a LAHSO clearance.
From the FAA library
- Chapter 9: Approaches and Landings › Go-Arounds (Rejected Landings)
Arounds (Rejected Landings) A go-around is a normal maneuver that is used when approach and landing parameters deviate from expectations or when it is hazardous to continue. Situations such as air traffic control (ATC) requirements, unexpected appearance of hazards ... overtaking another airplane, wind shear, wake turbulence, mechanical failure, or an unstable approach are all reasons to discontinue a landing approach. Like any other normal maneuver, the go-around should be practiced and perfected. The flight instructor should emphasize early…
- LANDINGS
LANDINGS Landing a skiplane is easy compared to landing with wheels; however, for off-airport landings, extra precautions are necessary. Be careful in choosing a landing site. Before landing, evaluate the site to be sure a safe departure will ... possible. Upon arriving at a prospective landing site, a pass should be made over the landing area to determine landing direction, and to determine if a safe approach and landing can be completed. A trial landing should be accomplished…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance
item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…
- LANDING › EMERGENCY LANDING
AROUND Whenever landing conditions are not satisfactory, execute a go-around. Potential conflicts with other aircraft, surface vessels or swimmers in the landing area, recognition of a hazard on the water, wind shear, wake turbulence, water surface conditions, mechanical failure ... unstabilized landing approach are a few of the reasons to discontinue a landing attempt. Climb to a safe altitude while executing the go-around checklist, then evaluate the situation, and make another approach under more favorable conditions. Remember that…
- Chapter 10: Teaching Practical Risk Management during Flight Instruction › Notes on Instructional Risk Management in the Flight Deck › Managing Risk while Teaching Landings
control or aircraft in the pattern. To avoid this, the instructor should only use concise prompting on approach to landings with the learner. Certain landings present unique risks. The instructor teaches the appropriate pre-landing reconnaissance for unfamiliar landing areas ... uncontrolled fields. During landings in strong winds, the instructor should have the skill sufficient to deal with the wind conditions. During a short-field or confined area landing, certain aircraft may fly at a slower approach speed. The instructor should…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-11. Pilot Responsibilities When Conducting Land and Hold Short Operations (LAHSO)
Land and Hold Short of a Designated Point on a Runway Other Than an Intersecting Runway or Taxiway 5. If, for any reason, such as difficulty in discerning the location of a LAHSO intersection, wind conditions, aircraft condition ... pilot elects to request to land on the full length of the runway, to land on another runway, or to decline LAHSO, a pilot is expected to promptly inform air traffic, ideally even before the clearance is issued. A LAHSO…