AI.VII.N.S3
SkillMake a timely decision to discontinue the approach to landing.
From the FAA library
- LANDINGS
LANDINGS Landing a skiplane is easy compared to landing with wheels; however, for off-airport landings, extra precautions are necessary. Be careful in choosing a landing site. Before landing, evaluate the site to be sure a safe departure will ... possible. Upon arriving at a prospective landing site, a pass should be made over the landing area to determine landing direction, and to determine if a safe approach and landing can be completed. A trial landing should be accomplished…
- Chapter 9: Approaches and Landings › Go-Arounds (Rejected Landings)
Arounds (Rejected Landings) A go-around is a normal maneuver that is used when approach and landing parameters deviate from expectations or when it is hazardous to continue. Situations such as air traffic control (ATC) requirements, unexpected appearance of hazards ... runway, overtaking another airplane, wind shear, wake turbulence, mechanical failure, or an unstable approach are all reasons to discontinue a landing approach. Like any other normal maneuver, the go-around should be practiced and perfected. The flight instructor should emphasize…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance
item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…
- LANDING › EMERGENCY LANDING
AROUND Whenever landing conditions are not satisfactory, execute a go-around. Potential conflicts with other aircraft, surface vessels or swimmers in the landing area, recognition of a hazard on the water, wind shear, wake turbulence, water surface conditions, mechanical failure ... unstabilized landing approach are a few of the reasons to discontinue a landing attempt. Climb to a safe altitude while executing the go-around checklist, then evaluate the situation, and make another approach under more favorable conditions. Remember that…
- Chapter 9: Approaches and Landings › Crosswind Approach and Landing
Common Errors Common errors with forward slips to a landing: 1. Incorrect pitch adjustments that result in poor airspeed control. 2. Reacting to erroneous airspeed indications. 3. Using excess power while trying to lose altitude. 4. A slip ... same direction as any crosswind. 5. Poor glidepath control. 6. Late transition to a sideslip during landing with crosswinds. 7. Landing without the longitudinal axis parallel to runway. 8. Landing off the centerline. Crosswind Approach and Landing Most runways…
- Chapter 9: Approaches and Landings › Emergency Approaches and Landings (Simulated)
Emergency Approaches and Landings (Simulated) During dual training flights, the instructor should give simulated emergency landings by retarding the throttle and calling “simulated emergency landing.” The objective of these simulated emergency landings is to develop a pilot’s accuracy, judgment ... planning, procedures, and confidence when little or no power is available. A simulated emergency landing may be given with the airplane in any configuration. If the simulated power failure occurs while above best glide speed, the pilot allows the airplane…