AI.X.C.R6
Risk managementEffect of environmental elements on airplane performance related to power-off stalls (e.g., turbulence, microbursts, and high-density altitude).
From the FAA library
- Chapter 13: Transition to Multiengine Airplanes › Spin Awareness and Stalls › Power-On Approach to Stall (Takeoff and Departure)
Power-On Approach to Stall (Takeoff and Departure) A power-on approach to stall is trained and checked to simulate problematic takeoff scenarios. A power-on approach to stall may be performed from straight-and-level flight or from shallow ... medium banked turns (up to 20 degrees of bank). To initiate a power-on approach to stall maneuver, the area surrounding the airplane should always be cleared to look for potential traffic. The airplane is slowed to the manufacturer…
- CHAPTER 2. FLIGHT TRAINING: STALLS › 200. STALL TRAINING › f. Stalls During Go-Arounds
Cross Controlled Stalls in Gliding Turns. Perform stalls in gliding turns to simulate turns from base to final. Perform the stalls from a properly coordinated turn, a slipping turn, and a skidding turn. Explain the difference between slipping and skidding ... turns. Explain the ball indicator position in each turn and the aircraft behavior in each of the stalls. e. Power-Off (Approach-To-Landing) Stalls (1) Have the student perform a full-flap, gear-extended, power-off stall with…
- Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Full Stalls, Power-On
Full Stalls, Power-On Power-on stall recoveries are practiced from straight climbs and climbing turns (15° to 20° bank) to help the pilot recognize the potential for an accidental stall during takeoff, go around, climb, or when trying ... clear an obstacle. Airplanes equipped with flaps or retractable landing gear should normally be in the takeoff configuration; however, power-on stalls should also be practiced with the airplane in a clean configuration (flaps and gear retracted) to ensure practice…
- Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Accelerated Stalls
Accelerated Stalls While pilots may understand the cause of an accelerated stall, it takes training to experience how these stalls develop and occur. The objectives of demonstrating an accelerated stall are to determine the stall characteristics of the airplane, experience ... stalls at speeds greater than the +1G stall speed, and develop the ability to instinctively recover at the onset of such stalls. This is a maneuver only commercial pilot and flight instructor applicants may be required to perform…
- Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Approaches to Stalls (Impending Stalls), Power-On or Power-Off
Approaches to Stalls (Impending Stalls), Power-On or Power-Off An impending stall occurs when the airplane is approaching, but does not exceed the critical AOA. The purpose of practicing impending stalls is to learn to retain or regain full ... control of the airplane immediately upon recognizing that it is nearing a stall, or that a stall is likely to occur if the pilot does not take appropriate action. Pilot training should emphasize teaching the same recovery technique for impending…
- CHAPTER 2. FLIGHT TRAINING: STALLS › 200. STALL TRAINING
CHAPTER 2. FLIGHT TRAINING: STALLS 200. STALL TRAINING. Flight instructor-airplane and flight instructor-glider applicants must be able to give stall training. The flight instructor should emphasize that techniques and procedures for each aircraft may differ and that pilots ... should be aware of the flight characteristics of each aircraft flown. The most effective training method contained in Report No. FAA-RD-77-26, General Aviation Pilot Stall Awareness Study, is the simulation of scenarios that can lead to inadvertent…