AI.X.F.S8

From the FAA library

• Airplane Flying Handbookp. 5-20
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Cross-Control Stall

  Cross-Control Stall The objective of the cross-control stall demonstration is to show the effects of uncoordinated flight on stall behavior and to emphasize the importance of maintaining coordinated flight while making turns. This is a demonstration-only maneuver ... required to perform it on a practical test. However, all pilots should be familiar with the situations that can lead to a cross-control stall, how to recognize and avoid this stall, and how to recover should one occur…

• Pilot's Handbook of Aeronautical Knowledgep. 6-2
  Chapter 6: Flight Controls › Flight Control Systems › Primary Flight Controls

  Flight Control Systems Flight Controls Aircraft flight control systems consist of primary and secondary systems. The ailerons, elevator (or stabilator), and rudder constitute the primary control system and are required to control an aircraft safely during flight. Wing flaps, leading ... edge devices, spoilers, and trim systems constitute the secondary control system and improve the performance characteristics of the airplane or relieve the pilot of excessive control forces. Primary Flight Controls Aircraft control systems are carefully designed to provide adequate responsiveness…

• Airplane Flying Handbookp. 5-19
  Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Accelerated Stalls

  Accelerated Stalls While pilots may understand the cause of an accelerated stall, it takes training to experience how these stalls develop and occur. The objectives of demonstrating an accelerated stall are to determine the stall characteristics of the airplane, experience ... stalls at speeds greater than the +1G stall speed, and develop the ability to instinctively recover at the onset of such stalls. This is a maneuver only commercial pilot and flight instructor applicants may be required to perform…

• Stall and Spin Awareness Trainingp. 9
  CHAPTER 2. FLIGHT TRAINING: STALLS › 200. STALL TRAINING › a. Stall Avoidance Practice at Slow Airspeeds

  This loss of power will result in a VMC lower than the stall speed at higher altitudes. (VMC is the minimum control speed with the critical engine inoperative). Also, some airplanes have such an effective rudder that even ... level VMC is lower than stall speed. For these airplanes, demonstrating loss of directional control may be safely conducted by limiting rudder travel to simulate maximum rudder available. Limiting rudder travel should be accomplished well above the power-off stall…

• Stall and Spin Awareness Trainingp. 5
  CHAPTER 1. GROUND TRAINING: STALL AND SPIN AWARENESS › 104. TYPES OF STALLS

  TYPES OF STALLS. Stalls can be practiced both with and without power. Stalls should be practiced to familiarize the student with the aircraft’s particular stall characteristics without putting the aircraft into a potentially dangerous condition. In multiengine airplanes, single ... engine stalls must be avoided. Descriptions of some different types of stalls follows: a. Power-off stalls (also known as approach-to-landing stalls) are practiced to simulate normal approach-to-landing conditions and configuration. Many stall/spin accidents have occurred…

• Airplane Flying Handbookp. 13-26
  Chapter 13: Transition to Multiengine Airplanes › Engine Inoperative Flight Principles › VMC Demo Stall Avoidance

  airplane to the entry airspeed. Note that noise within the flight deck may mask the sound of the stall warning horn. While the VMC demonstration shows the earliest onset of a loss of directional control when performed in accordance with ... foregoing procedures, avoid a stalled condition. Avoid stalls with asymmetrical thrust, such that the VMC demonstration does not degrade into a single-engine stall. A VMC demonstration that is allowed to degrade into a single-engine stall with high asymmetrical…