AI.XII.A.R3
Risk managementConfiguring the airplane.
From the FAA library
- Chapter 18: Emergency Procedures › Basic Safety Concepts › Airplane Configuration
Airplane Configuration Since flaps improve maneuverability at slow speed, and lower the stalling speed, their use during final approach is recommended when time and circumstances permit. However, the associated increase in drag and decrease in gliding distance call for caution ... available, a gear-up landing on level, but soft terrain or across a plowed field may result in less airplane damage than a gear-down landing. [Figure 18-3] Deactivation of the airplane’s electrical system before touchdown reduces…
- Index
twin-engine airplane with one engine inoperative that involves a small amount of bank and slightly uncoordinated flight to align the fuselage with the direction of travel and minimize drag. Zero thrust (simulated feather). An engine configuration with ... distance Accelerate-stop distance After-landing After-landing roll Aircraft energy management Airframe and systems Airplane-based UPRT Airplane configuration Airplane equipment and lighting Airport and navigation lighting aids Airport traffic patterns and operations All-attitude/all-envelope flight training methods…
- Chapter 3: Basic Flight Maneuvers › Glides
AFM/POH specifies the procedure. In general, emergency descent procedures are high drag, high airspeed procedures requiring a specific airplane configuration (such as power to idle, propellers forward, landing gear extended, and flaps retracted), and a specific emergency descent airspeed. Emergency…
- Chapter 9: Approaches and Landings › Use of Flaps
section in this chapter may help. When needed, additional flight instruction enhances safety. The manufacturer’s recommended procedures, including airplane configuration and airspeeds, and other information relevant to approaches and landings in a specific make and model airplane are contained…
- Chapter 5: Aerodynamics of Flight › Effect of Wing Planform
combined with low aspect ratio, it results in flying qualities very different from a more conventional high aspect ratio airplane configuration. Such airplanes require very precise and professional flying techniques, especially at slow speeds, while airplanes with a high aspect…
- Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Slow Flight › Performing the Slow Flight Maneuver
desired configuration (i.e., approximately 5–10 knots above the stall speed for that flight condition), additional power will be needed to maintain altitude. During these changing flight conditions, the pilot should trim the airplane to compensate for changes in control ... extended to the landing position, as applicable. It is recommended the prescribed before-landing checks be completed to configure the airplane. The extension of gear and flaps typically occurs once cruise power has been reduced and at appropriate airspeeds…