AI.XII.G.S1

From the FAA library

• Pilot's Handbook of Aeronautical Knowledgep. 2-19
  Chapter 2: Aeronautical Decision-Making › TEAM Checklist: Choose and Implement Risk Controls › The DECIDE Model

  First, adjust the power to the maximum controllable level on both engines. Because the left engine is the only engine delivering thrust, the yaw increases to the right, which necessitates application of additional left rudder application. Figure ... DECIDE model has been recognized worldwide. Its application is illustrated in column A while automatic/naturalistic decision-making is shown in column B. The failed engine is the side that requires no rudder pressure, in this case the right engine. Second…

• Airplane Flying Handbookp. 13-30
  Chapter 13: Transition to Multiengine Airplanes › Low Altitude Engine Failure Scenarios › Landing Gear Control Selected Up, Single-Engine Climb Performance Inadequate

  Landing Gear Control Selected Up, Single-Engine Climb Performance Inadequate When operating near or above the single-engine ceiling and an engine failure is experienced shortly after lift-off, a landing needs to be accomplished on whatever essentially lies ahead ... Figure 13-19] There is also the option of continuing ahead, in a descent at VYSE with the remaining engine producing power, as long as the pilot is not tempted to remain airborne beyond the airplane’s performance capability. Remaining…

• Airplane Flying Handbookp. 13-33
  Chapter 13: Transition to Multiengine Airplanes › Low Altitude Engine Failure Scenarios › Checklist

  overrun available to land on. The use of wing flaps for takeoff virtually eliminates the likelihood of a single-engine climb until the flaps are retracted. There are two time-tested memory aids the pilot may find useful in dealing ... with engine-out scenarios. The first, “dead foot—dead engine” is used to assist in identifying the failed engine. Depending on the failure mode, the pilot will not be able to consistently identify the failed engine in a timely manner…

• Pilot's Handbook of Aeronautical Knowledgep. 6-2
  Chapter 6: Flight Controls › Flight Control Systems › Primary Flight Controls

  Flight Control Systems Flight Controls Aircraft flight control systems consist of primary and secondary systems. The ailerons, elevator (or stabilator), and rudder constitute the primary control system and are required to control an aircraft safely during flight. Wing flaps, leading ... edge devices, spoilers, and trim systems constitute the secondary control system and improve the performance characteristics of the airplane or relieve the pilot of excessive control forces. Primary Flight Controls Aircraft control systems are carefully designed to provide adequate responsiveness…

• Airplane Flying Handbookp. 13-23
  Chapter 13: Transition to Multiengine Airplanes › Engine Inoperative Flight Principles › Derivation of VMC

  critical engine is the engine whose failure had the most adverse effect on directional control. On twins with each engine rotating in conventional, clockwise rotation as viewed from the pilot's seat, the critical engine will be the left engine ... Multiengine airplanes are subject to P-factor just as single-engine airplanes are. The descending propeller blade of each engine will produce greater thrust than the ascending blade when the airplane is operated under power and at positive angles…

• Aviation Instructor's Handbookp. 9-8
  Chapter 9: Techniques of Flight Instruction › Positive Exchange of Flight Controls › Procedure

  Procedure During flight training, there should always be a clear understanding between learners and flight instructors about who has control of the aircraft. The preflight briefing should include procedures for the exchange of flight controls. A positive three-step process ... exchange of flight controls between pilots is a proven procedure and one that is strongly recommended. When an instructor is teaching a maneuver to a learner, the instructor normally demonstrates the maneuver first, then has the learner follow along…