Flight Instructor for Airplane Category › XIII. Multiengine Operations › Task B. VMC Demonstration (AMEL, AMES)

AI.XIII.B.S1d

Skill

Configure the airplane in accordance with the manufacturer’s recommendations, in the absence of the manufacturer’s recommendations, then at safe single-engine speed (VSSE/VYSE), as appropriate, and:

Trim set for takeoff

Practice questions Ask the tutor

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Airplane Flying Handbook p. 17-10
Chapter 17: Transition to Light Sport Airplanes (LSA) › Flight Environment › Inside the Airplane
correctly set prior to takeoff. Because trim positioning/indicting systems vary widely in light-sport airplanes, pilots should fully understand not only how to position the trim, but also how to respond to a trim-run-away condition. Part ... nose-down directions, verifying that the trim disconnect (if equipped) is properly functioning, and then properly setting the takeoff trim position. Figure 17-12. Trim control. Depending on the engine manufacturer, the engine controls may be completely familiar…
Airplane Flying Handbook p. 5-20
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Elevator Trim Stall
around procedure from a normal landing approach or a simulated, forced-landing approach, or immediately after a takeoff, with the trim set for a normal landing approach glide at idle power. The demonstration shows the importance of making smooth power…
Airplane Flying Handbook p. 2-21
Chapter 2: Ground Operations › Before-Takeoff Check
Fuel System—set per the AFM/POH and verified ON and the proper and correct fuel tanks selected. ⦁ Trim—set for takeoff position, which includes the elevator and may also include rudder and aileron trim. ⦁ Flight Controls—checked throughout their entire…
Airplane Flying Handbook p. 13-26
Chapter 13: Transition to Multiengine Airplanes › Engine Inoperative Flight Principles › VMC Demo
With the landing gear retracted and the flaps set to the takeoff position, the pilot slows the airplane to approximately 10 knots above VSSE or VYSE (whichever is higher) and trims for takeoff. For the remainder of the maneuver ... trim setting remains unaltered. The pilot selects an entry heading and sets high rpm on both propeller controls. Power on the left engine is throttled back to idle as the right engine power is advanced to the takeoff setting…
Airplane Flying Handbook p. 5-10
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Slow Flight › Performing the Slow Flight Maneuver
cruising to approach speeds without changes in altitude or heading, while increasing the angle of attack and setting the required power and trim. ⦁ Configuration changes, such as extending the landing gear and adding flaps, while maintaining heading and altitude. ⦁ Turning ... medium-banked (approximately 20 degrees) turns, and straight-ahead power-off gliding descents and descending turns, which represent the takeoff and landing phases of flight. Slow flight in a single-engine airplane should be conducted so the maneuver…
Airplane Flying Handbook p. 6-5
Chapter 6: Takeoffs and Departure Climbs › Normal Takeoff › Initial Climb
power to the recommended climb setting and trim the airplane to relieve the control pressures. This makes it easier to hold a constant attitude and airspeed. During initial climb, it is important that the takeoff path remain aligned with…