AI.XIII.B.S6
SkillRecover promptly by simultaneously reducing power sufficiently on the operating engine, decreasing the angle of attack as necessary to regain airspeed and directional control, and without adding power on the simulated failed engine.
From the FAA library
- Chapter 6: Flight Controls › Flight Control Systems › Primary Flight Controls
Flight Control Systems Flight Controls Aircraft flight control systems consist of primary and secondary systems. The ailerons, elevator (or stabilator), and rudder constitute the primary control system and are required to control an aircraft safely during flight. Wing flaps, leading ... edge devices, spoilers, and trim systems constitute the secondary control system and improve the performance characteristics of the airplane or relieve the pilot of excessive control forces. Primary Flight Controls Aircraft control systems are carefully designed to provide adequate responsiveness…
- Chapter 13: Transition to Multiengine Airplanes › Engine Inoperative Flight Principles › VMC Demo Stall Avoidance
reducing the angle of attack as the throttle is retarded and return the airplane to the entry airspeed. Note that noise within the flight deck may mask the sound of the stall warning horn. While the VMC demonstration shows ... earliest onset of a loss of directional control when performed in accordance with the foregoing procedures, avoid a stalled condition. Avoid stalls with asymmetrical thrust, such that the VMC demonstration does not degrade into a single-engine stall…
- Chapter 13: Transition to Multiengine Airplanes › Engine Inoperative Flight Principles › Derivation of VMC
Engine Inoperative Flight Principles There are two main considerations for OEI operations—performance and control. Multiengine pilots learn to operate the airplane for maximum rate of climb performance at the blue radial indicated airspeed by training to fly without sideslip ... Pilots also learn to recognize and recover from loss of directional control associated with the red radial indicated airspeed by performing a VMC demonstration. Since the object of a VMC demonstration is not performance, sideslip occurs during the maneuver. Detailed…
- Chapter 13: Transition to Multiengine Airplanes › Engine Inoperative Flight Principles › ⦁ All propeller controls in the recommended takeoff position throughout VMC determination
determination of VMC in certification is solely concerned with the minimum speed for directional control under a very specific set of circumstances, and not the optimum airplane attitude or configuration for climb performance. During dynamic VMC determination in aircraft certification ... cuts of the critical engine using the mixture control are performed by flight test pilots while gradually reducing the speed with each attempt. VMC is the minimum speed at which directional control could be maintained within 20° of the original…
- Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Slow Flight
pilot training and testing purposes, slow flight includes two main elements: ⦁ Slowing to, maneuvering at, and recovering from an airspeed at which the airplane is still capable of maintaining controlled flight without activating the stall warning—5 to 10 knots ... appropriate to takeoffs, climbs, descents, approaches to landing, and go-arounds. Slow flight should be introduced with the target airspeed sufficiently above the stall to permit safe maneuvering, but close enough to the stall warning for the pilot to experience…