AP.I.A.K14
KnowledgePitot-static system–associated instruments and the power source for those flight instruments. Operation and power sources for other flight instruments.
From the FAA library
- Chapter 6: Flight Controls › Autopilot
Three different servos actuate ailerons, elevator, and rudder. More advanced systems often include a vertical speed and/or indicated airspeed hold mode. Advanced autopilot systems are coupled to navigational aids through a flight director. Figure 6-22. A ground adjustable ... Some aircraft, including most jet transports, use an adjustable stabilizer to provide the required pitch trim forces. The autopilot system also incorporates a disconnect safety feature to disengage the system automatically or manually. These autopilots work with inertial navigation systems…
- Chapter 9: Flight Manuals and Other Documents
Chapter Summary Flight instruments enable an aircraft to be operated with maximum performance and enhanced safety, especially when flying long distances. Manufacturers provide the necessary flight instruments, but to use them effectively, pilots need to understand how they operate ... pilot, it is important to become very familiar with the operational aspects of the pitot-static system and associated instruments, the vacuum system and associated instruments, the gyroscopic instruments, and the magnetic compass. Chapter 9: Flight Manuals and Other Documents…
- Appendix B: Acronyms, Abbreviations, and NOTAM Contractions
federal FEIS—Final Environmental Impact Statement FEP—front end processor FFAC—from facility FI/P—flight inspection permanent FI/T—flight inspection temporary FIFO—Flight Inspection Field Office FIG—flight inspection group FINO—Flight Inspection National Field Office FIPS—federal information publication ... standard FIR—flight information region FIRE—fire station FIRMR—Federal Information Resource Management Regulation FL—flight level FLOWSIM—traffic flow planning simulation FM—from FMA—final monitor aid FMF—facility master file FMIS—FTS2000 management information system FMS—flight management…
- Chapter 8: Flight Instruments › Blocked Static System
Blocked Static System If the static system becomes blocked but the pitot tube remains clear, the ASI continues to operate; however, it is inaccurate. The airspeed indicates lower than the actual airspeed when the aircraft is operated above the altitude ... where the static ports became blocked because the trapped static pressure is higher than normal for that altitude. When operating at a lower altitude, a faster than actual airspeed is displayed due to the relatively low static pressure trapped…
- Chapter 6: Flight Controls › Flight Control Systems › Primary Flight Controls
Flight Control Systems Flight Controls Aircraft flight control systems consist of primary and secondary systems. The ailerons, elevator (or stabilator), and rudder constitute the primary control system and are required to control an aircraft safely during flight. Wing flaps, leading ... edge devices, spoilers, and trim systems constitute the secondary control system and improve the performance characteristics of the airplane or relieve the pilot of excessive control forces. Primary Flight Controls Aircraft control systems are carefully designed to provide adequate responsiveness…
- Chapter 7: Aircraft Systems › Heating System › Exhaust Heating Systems
Exhaust Heating Systems Exhaust heating systems are the simplest type of aircraft heating system and are used on most light aircraft. Exhaust heating systems are used to route exhaust gases away from the engine and fuselage while reducing engine noise ... exhaust systems also serve as a heat source for the cabin and carburetor. The risks of operating an aircraft with a defective exhaust heating system include carbon monoxide poisoning, a decrease in engine performance, and an increased potential…