AP.I.A.K9
KnowledgePneumatic and environmental systems–heating, cooling, ventilation, oxygen, pressurization, supply for ice protection systems, controls, indicators, and regulating devices.
From the FAA library
- Chapter 7: Aircraft Systems › Heating System › Exhaust Heating Systems
Exhaust Heating Systems Exhaust heating systems are the simplest type of aircraft heating system and are used on most light aircraft. Exhaust heating systems are used to route exhaust gases away from the engine and fuselage while reducing engine noise ... exhaust systems also serve as a heat source for the cabin and carburetor. The risks of operating an aircraft with a defective exhaust heating system include carbon monoxide poisoning, a decrease in engine performance, and an increased potential for fire…
- Chapter 7: Aircraft Systems › Oxygen Systems › Pressure-Demand Oxygen Systems
Pressure-Demand Oxygen Systems Pressure-demand oxygen systems are similar to diluter demand oxygen equipment, except that oxygen is supplied to the mask under pressure at cabin altitudes above 34,000 feet. Pressure-demand regulators create airtight and oxygen-tight ... seals, but they also provide a positive pressure application of oxygen to the mask face piece that allows the user’s lungs to be pressurized with oxygen. This feature makes pressure demand regulators safe at altitudes above 40,000 feet…
- Chapter 7: Aircraft Systems › Oxygen Systems › Servicing of Oxygen Systems
Servicing of Oxygen Systems Before servicing any aircraft with oxygen, consult the specific aircraft service manual to determine the type of equipment required and procedures to be used. Certain precautions should be observed whenever aircraft oxygen systems ... serviced. Oxygen system servicing should be accomplished only when the aircraft is located outside of the hangars. Personal cleanliness and good housekeeping are imperative when working with oxygen. Oxygen under pressure creates spontaneous results when brought in contact with petroleum…
- Chapter 6: Flight Controls › Flight Control Systems › Primary Flight Controls
Flight Control Systems Flight Controls Aircraft flight control systems consist of primary and secondary systems. The ailerons, elevator (or stabilator), and rudder constitute the primary control system and are required to control an aircraft safely during flight. Wing flaps, leading ... edge devices, spoilers, and trim systems constitute the secondary control system and improve the performance characteristics of the airplane or relieve the pilot of excessive control forces. Primary Flight Controls Aircraft control systems are carefully designed to provide adequate responsiveness…
- Chapter 7: Aircraft Systems › Oil Systems
Systems The engine oil system performs several important functions: • Lubrication of the engine’s moving parts • Cooling of the engine by reducing friction • Removing heat from the cylinders • Providing a seal between the cylinder walls and pistons • Carrying away contaminants ... Figure 7-17. Wet-sump oil system. Reciprocating engines use either a wet-sump or a dry-sump oil system. In a wet-sump system, the oil is located in a sump that is an integral part of the engine…
- Chapter 7: Aircraft Systems › Anti-Ice and Deice Systems › Airfoil Anti-Ice and Deice
Proper maintenance and care of deicing boots are important for continued operation of this system. They need to be carefully inspected during preflight. Another type of leading edge protection is the thermal anti-ice system. Heat provides ... most effective methods for preventing ice accumulation on an airfoil. High performance turbine aircraft often direct hot air from the compressor section of the engine to the leading edge surfaces. The hot air heats the leading edge surfaces sufficiently…