AP.II.B.K3
KnowledgeMalfunctions during powerplant start, procedures to address the malfunction, and any associated limitations.
From the FAA library
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-9. Procedure Turn and Hold-in-lieu of Procedure Turn
pilot is uncertain whether the ATC clearance intends for a procedure turn to be conducted or to allow for a straight-in approach, the pilot must immediately request clarification from ATC (14 CFR section 91.123). 1. On U.S. Government charts ... barbed arrow indicates the maneuvering side of the outbound course on which the procedure turn is made. Headings are provided for course reversal using the 45 degree type procedure turn. However, the point at which the turn may be commenced…
- Chapter 5. Air Traffic Procedures › Section 2. Departure Procedures › 5-2-1. Pre-taxi Clearance Procedures
Section 2. Departure Procedures 5-2-1. Pre-taxi Clearance Procedures a. Certain airports have established pre-taxi clearance programs whereby pilots of departing instrument flight rules (IFR) aircraft may elect to receive their IFR clearances before they start taxiing ... takeoff. The following provisions are included in such procedures: 1. Pilot participation is not mandatory. 2. Participating pilots call clearance delivery or ground control not more than 10 minutes before proposed taxi time. 3. IFR clearance (or delay information…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-16. Simultaneous Close Parallel PRM Approaches and Simultaneous Offset Instrument A…
high update rate surveillance sensor is a component of this system only for specific runway spacing. Additional procedures for simultaneous independent approaches are described in paragraph 5-4-15, Simultaneous Independent ILS/RNAV/GLS Approaches. 2. Simultaneous Close Parallel PRM approaches, whether ... AAUP, and use of a secondary PRM communications frequency. PRM approaches are depicted on a separate IAP titled (Procedure type) PRM Rwy XXX (Simultaneous Close Parallel or Close Parallel). ATC does not use the word “independent” when advertising these operations…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-5. Instrument Approach Procedure (IAP) Charts
type of equipment may be used to execute the final approach (e.g., VOR or GPS RWY 15). NOTE-This procedure identification method has changed and these procedures will be revised in the course of the normal procedure amendment process ... slash and equipment (e.g., /DME) information will be removed with future amendments. Pilots should review the procedure’s notes, planview annotations, and PBN/equipment requirements boxes to determine the capability needed to accomplish the procedure. (b) In some cases, other types…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-7. Instrument Approach Procedures
involved in an emergency situation will be given priority. If the pilot is not familiar with the specific approach procedure, ATC should be advised and they will provide detailed information on the execution of the procedure. h. The name ... issued that the inoperative or unreliable approach aid component is unusable, except when the title of the published approach procedures otherwise allows, for example, ILS or LOC. i. Pilots planning flights to locations which are private airfields or which have…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-1. Standard Terminal Arrival (STAR) Procedures
until the next published speed restriction on the STAR, or until it is necessary to comply with the speed limits published in 14 CFR §91.117. NOTE-The “expect” altitudes/speeds are published so that pilots may have the information for planning ... intends to clear the aircraft back onto the STAR, controllers will advise pilots where to expect to resume the procedure. Pilots should then be prepared to rejoin the STAR at the subsequent fix or procedure leg. (a) Clearance to “descend…