AP.II.C.K2
KnowledgeTaxi instructions/clearances, including published taxi routes.
From the FAA library
- Chapter 5. Air Traffic Procedures › Section 2. Departure Procedures › 5-2-1. Pre-taxi Clearance Procedures
Section 2. Departure Procedures 5-2-1. Pre-taxi Clearance Procedures a. Certain airports have established pre-taxi clearance programs whereby pilots of departing instrument flight rules (IFR) aircraft may elect to receive their IFR clearances before they start taxiing ... takeoff. The following provisions are included in such procedures: 1. Pilot participation is not mandatory. 2. Participating pilots call clearance delivery or ground control not more than 10 minutes before proposed taxi time. 3. IFR clearance (or delay information…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-18. Taxiing
When issuing taxi instructions to any point other than an assigned takeoff runway, ATC will specify the point to taxi to, issue taxi instructions, and state any hold short instructions or runway crossing clearances if the taxi route will cross ... runway. NOTEATC is required to obtain a readback from the pilot of all runway hold short instructions. 8. If a pilot is expected to hold short of a runway approach/departure (Runway XX APPCH/Runway XX DEP) hold area or ILS holding…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-21. Exiting the Runway After Landing
operating control tower, pilots should not stop or reverse course on the runway without first obtaining ATC approval. b. Taxi clear of the runway unless otherwise directed by ATC. An aircraft is considered clear of the runway when all parts ... there are no restrictions to its continued movement beyond the runway holding position markings. In the absence of ATC instructions, the pilot is expected to taxi clear of the landing runway by taxiing beyond the runway holding position markings associated…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-17. VFR Helicopter Operations at Controlled Airports
clearances are in no way intended to place the helicopter in a hazardous position. It is expected that pilots will advise ATC if a specific clearance will cause undue hazards to persons or property. b. Controllers normally limit ATC ground ... service and instruction to movement areas; therefore, operations from nonmovement areas are conducted at pilot discretion and should be based on local policies, procedures, or letters of agreement. In order to maximize the flexibility of helicopter operations, it is necessary…
- Chapter 1: Departure Procedures › Standardized Taxi Routes
Standardized Taxi Routes Standard taxi routes improve ground management at high-density airports, namely those that have airline service. At these airports, typical taxiway traffic patterns used to move aircraft between gate and runway are laid out and coded ... specialist (ATCS) can reduce radio communication time and eliminate taxi instruction misinterpretation by simply clearing the pilot to taxi via a specific, named route. An example of this would be Los Angeles International Airport (KLAX), where North Route is used…