AP.II.F.R7
Risk managementPotential powerplant failure during takeoff or other malfunction considering operational factors such as aircraft characteristics, runway/takeoff path length, surface.
From the FAA library
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance
Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance
Takeoff and Landing Performance The majority of pilot-caused aircraft accidents occur during the takeoff and landing phase of flight. Because of this fact, the pilot must be familiar with all the variables that influence the takeoff and landing performance ... aircraft and must strive for exacting, professional procedures of operation during these phases of flight. Takeoff and landing performance is a condition of accelerated and decelerated motion. For instance, during takeoff an aircraft starts at zero speed and accelerates…
- Chapter 6: Takeoffs and Departure Climbs › Prior to Takeoff
When operating from a towered airport, pilots need to contact the tower operator and receive a takeoff clearance before taxiing onto the active runway. Taking off immediately behind another aircraft, particularly a large and heavy transport airplane, creates the risk ... wake turbulence encounter, and a possible loss of control. However, if an immediate takeoff behind a large heavy aircraft is necessary, the pilot should plan to minimize the chances of flying through an aircraft’s wake turbulence by avoiding…
- Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Takeoff Roll
pilot not flying. Retarding a thrust lever would only be necessary in case an engine exceeds any limitation. Takeoff data, including V1/VR and V2 speeds, takeoff power settings, and required field length should be computed prior to each takeoff ... make and model without an FMS, the data should be recorded on a takeoff data card. This data is based on airplane weight, runway length available, runway gradient, field temperature, field barometric pressure, wind, icing conditions, and runway condition. Both…