AP.II.F.S2
SkillCoordinate with crew, if applicable, and complete the appropriate checklist(s) prior to takeoff in a timely manner.
From the FAA library
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance
Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance
Takeoff and Landing Performance The majority of pilot-caused aircraft accidents occur during the takeoff and landing phase of flight. Because of this fact, the pilot must be familiar with all the variables that influence the takeoff and landing performance ... aircraft and must strive for exacting, professional procedures of operation during these phases of flight. Takeoff and landing performance is a condition of accelerated and decelerated motion. For instance, during takeoff an aircraft starts at zero speed and accelerates…
- Chapter 16: Navigation › Using the VOR › Time and Distance Check From a Station Using a RMI
Time and Distance Check From a Station Using a RMI To compute time and distance from a station, first turn the aircraft to place the RMI bearing pointer on the nearest 90° index. Note the time and maintain the heading ... When the RMI bearing pointer has moved 10°, note the elapsed time in seconds and apply the formulas in the following example to determine the approximate time and distance from a given station. [Figure 16-33] The time from station…
- Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Takeoff Roll
pilot not flying. Retarding a thrust lever would only be necessary in case an engine exceeds any limitation. Takeoff data, including V1/VR and V2 speeds, takeoff power settings, and required field length should be computed prior to each takeoff ... make and model without an FMS, the data should be recorded on a takeoff data card. This data is based on airplane weight, runway length available, runway gradient, field temperature, field barometric pressure, wind, icing conditions, and runway condition. Both…
- Chapter 6: Takeoffs and Departure Climbs › Crosswind Takeoff › Takeoff Roll
Crosswind Takeoff While it is usually preferable to take off directly into the wind whenever possible or practical, there are many instances when circumstances or judgment indicate otherwise. Therefore, the pilot must be familiar with the principles and techniques involved ... crosswind takeoffs, as well as those for normal takeoffs. A crosswind affects the airplane during takeoff much as it does during taxiing. With this in mind, the pilot should be aware that the technique used for crosswind correction during takeoffs…