AP.III.B.S11
SkillMaintain flight path and continue climb to the appropriate altitude at the recommended airspeed and configuration.
From the FAA library
- Chapter 11: Aircraft Performance › Performance › Climb Performance
Positive climb performance occurs when an aircraft gains PE by increasing altitude. Two basic factors, or a combination of the two factors, contribute to positive climb performance in most aircraft: 1. The aircraft climbs (gains PE) using excess power above ... that required to maintain level flight, or 2. The aircraft climbs by converting airspeed (KE) to altitude (PE). As an example of factor 1 above, an aircraft with an engine capable of producing 200 horsepower (at a given altitude…
- Chapter 5: Aerodynamics of Flight › Aerodynamic Forces in Flight Maneuvers › Forces in Descents
Figure 5-36. Changes in lift during climb entry. The thrust required for a stabilized climb equals drag plus a percentage of weight dependent on the angle of climb. For example, a 10° climb would require thrust to equal drag ... plus 17 percent of weight. To climb straight up would require thrust to equal all of weight and drag. Therefore, the angle of climb for climb performance is dependent on the amount of excess thrust available to overcome a portion…
- Chapter 11: Aircraft Performance › Performance › Rate of Climb (ROC)
Rate of Climb (ROC) ROC is a comparison of altitude gained relative to the time needed to reach that altitude. ROC is simply the vertical component of the aircraft’s flight path velocity vector. For maximum ROC performance, a pilot ... flies the aircraft at VY so as to achieve a maximum gain in altitude over a given period of time. Maximum ROC expedites a climb to an assigned altitude. This gains the greatest vertical distance over a period of time…
- Chapter 5: Aerodynamics of Flight › Aerodynamic Forces in Flight Maneuvers › Forces in Climbs
Figure 5-35. Normal, slipping, and skidding turns at a constant altitude. If the climb is entered with no change in power setting, the airspeed gradually diminishes because the thrust required to maintain a given airspeed in level flight ... insufficient to maintain the same airspeed in a climb. When the flight path is inclined upward, a component of the aircraft’s weight acts in the same direction as, and parallel to, the total drag of the aircraft, thereby increasing…
- Chapter 11: Aircraft Performance › Climb Performance Factors › Region of Reversed Command
power required curve represents the speed at which the lowest brake horsepower sustains level flight. This is termed the best endurance airspeed. An airplane performing a low airspeed, high pitch attitude power approach for a short-field landing ... this situation, without the use of power, would result in a rapid sink rate and corresponding loss of altitude. If during a soft-field takeoff and climb, for example, the pilot attempts to climb out of ground effect without first…
- Chapter 3: Basic Flight Maneuvers › Climbs and Climbing Turns
Normal climb speed is generally higher than the airplane’s best rate of climb. The additional airspeed provides for better engine cooling, greater control authority, and better visibility over the nose of the airplane. Normal climb is sometimes referred ... cruise climb. ⦁ Best rate of climb (VY)—produces the most altitude gained over a given amount of time. This airspeed is typically used when initially departing a runway without obstructions until it is safe to transition to a normal…