AP.III.B.S7
SkillMaintain centerline and coordinated flight control inputs during the takeoff roll.
From the FAA library
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance
Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…
- Chapter 8: Flight Instruments › Gyroscopic Flight Instruments › Turn Coordinator
Turn Coordinator The gimbal in the turn coordinator is canted; therefore, its gyro can sense both rate of roll and rate of turn. Since turn coordinators are more prevalent in training aircraft, this discussion concentrates on that instrument. When rolling ... into or out of a turn, the miniature aircraft banks in the direction the aircraft is rolled. A rapid roll rate causes the miniature aircraft to bank more steeply than a slow roll rate. The turn coordinator can be used…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance
Takeoff and Landing Performance The majority of pilot-caused aircraft accidents occur during the takeoff and landing phase of flight. Because of this fact, the pilot must be familiar with all the variables that influence the takeoff and landing performance ... aircraft and must strive for exacting, professional procedures of operation during these phases of flight. Takeoff and landing performance is a condition of accelerated and decelerated motion. For instance, during takeoff an aircraft starts at zero speed and accelerates…
- Chapter 6: Takeoffs and Departure Climbs › Crosswind Takeoff › Takeoff Roll
Crosswind Takeoff While it is usually preferable to take off directly into the wind whenever possible or practical, there are many instances when circumstances or judgment indicate otherwise. Therefore, the pilot must be familiar with the principles and techniques involved ... crosswind takeoffs, as well as those for normal takeoffs. A crosswind affects the airplane during takeoff much as it does during taxiing. With this in mind, the pilot should be aware that the technique used for crosswind correction during takeoffs…
- Chapter 16: Transition to Jet-Powered Airplanes › Jet Airplane Takeoff and Climb › Takeoff Roll
Rolling takeoffs can also be made from the end of the runway by advancing the thrust levers from idle as the brakes are released. During the takeoff roll, the pilot flying should concentrate on directional control of the airplane. This ... torque-produced yawing in a jet as there is in a propeller-driven airplane. The airplane should be maintained exactly on centerline with the wings level. This automatically aids the pilot when contending with an engine failure. If a crosswind…
- Chapter 6: Takeoffs and Departure Climbs › Normal Takeoff › Takeoff Roll
pilot should also ensure that the takeoff surfaces are firm and of sufficient length to permit the airplane to gradually accelerate to normal lift-off and climb-out speed, and there are no obstructions along the takeoff path. There ... reasons for making a takeoff as nearly into the wind as possible. First, since the airplane depends on airspeed, a headwind provides some of that airspeed even before the airplane begins to accelerate into the wind. Second, a headwind decreases…