AP.V.H.S4
SkillCoordinate with crew, if applicable, and complete the appropriate procedures and checklist(s) in a timely manner.
From the FAA library
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-21. Missed Approach
provided, the pilot should conform to radar vectors when provided by ATC in lieu of the published missed approach procedure. (See FIG 5-4-31.) e. Some locations may have a preplanned alternate missed approach procedure ... event the primary NAVAID used for the missed approach procedure is unavailable. To avoid confusion, the alternate missed approach instructions are not published on the chart. However, the alternate missed approach holding pattern will be depicted on the instrument approach…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-5. Instrument Approach Procedure (IAP) Charts
type of equipment may be used to execute the final approach (e.g., VOR or GPS RWY 15). NOTE-This procedure identification method has changed and these procedures will be revised in the course of the normal procedure amendment process ... slash and equipment (e.g., /DME) information will be removed with future amendments. Pilots should review the procedure’s notes, planview annotations, and PBN/equipment requirements boxes to determine the capability needed to accomplish the procedure. (b) In some cases, other types…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-10. Timed Approaches from a Holding Fix
When a teardrop procedure turn is depicted and a course reversal is required, this type turn must be executed. 3. When a holding pattern replaces a procedure turn, the holding pattern must be followed, except when RADAR VECTORING is provided ... when NoPT is shown on the approach course. The recommended entry procedures will ensure the aircraft remains within the holding pattern’s protected airspace. As in the procedure turn, the descent from the minimum holding pattern altitude to the final…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-7. Instrument Approach Procedures
involved in an emergency situation will be given priority. If the pilot is not familiar with the specific approach procedure, ATC should be advised and they will provide detailed information on the execution of the procedure. h. The name ... unreliable. The controller will use the name of the approach as published, but must advise the aircraft at the time an approach clearance is issued that the inoperative or unreliable approach aid component is unusable, except when the title…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-9. Procedure Turn and Hold-in-lieu of Procedure Turn
established on course, it is their responsibility to so advise ATC upon receipt of their approach clearance. 6. A procedure turn is not required when an approach can be made directly from a specified intermediate fix to the final approach ... such cases, the term “NoPT” is used with the appropriate course and altitude to denote that the procedure turn is not required. If a procedure turn is desired, and when cleared to do so by ATC, descent below the procedure…
- 14 CFR Part 141, Appendix J to Part 141—Aircraft Type Rating Course, For Other Than an Airline Transport Pilot Certificate
Airline Transport Pilot Certificate (1) A type rating for an airplane—single-engine course: (i) Preflight preparation; (ii) Preflight procedures; (iii) Takeoff and departure phase; (iv) In-flight maneuvers; (v) Instrument procedures; (vi) Landings and approaches to landings; (vii) Normal ... abnormal procedures; (viii) Emergency procedures; and (ix) Postflight procedures. (2) A type rating for an airplane—multiengine course: (i) Preflight preparation; (ii) Preflight procedures; (iii) Takeoff and departure phase; (iv) In-flight maneuvers; (v) Instrument procedures; (vi) Landings and approaches…