AP.VI.D.S14
SkillUse runway incursion avoidance procedures, if applicable.
From the FAA library
- Chapter 14: Airport Operations › Collision Avoidance › Runway Incursion Avoidance
preflight planning, before descending to land and while taxiing, as needed. • Know airport signage. • Review NOTAM for information on runway/ taxiway closures and construction areas. • Request progressive taxi instructions from ATC when unsure of the taxi route. • Check for traffic ... before crossing any runway hold line and before entering a taxiway. • Turn on aircraft lights and the rotating beacon or strobe lights while taxing. • When landing, clear the active runway as soon as possible, then wait for taxi instructions before…
- Chapter 14: Airport Operations › En Route › Vortex Avoidance Procedures
Vortex Avoidance Procedures The following procedures are in place to assist pilots in vortex avoidance in the given scenario. • Landing behind a larger aircraft on the same runway— stay at or above the larger aircraft’s approach flight path ... land beyond its touchdown point. [Figure 14-47A] • Landing behind a larger aircraft on a parallel runway closer than 2,500 feet—consider the possibility of drift and stay at or above the larger aircraft’s final approach flight…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Runway Surface and Gradient
Runway Surface and Gradient Runway conditions affect takeoff and landing performance. Typically, performance chart information assumes paved, level, smooth, and dry runway surfaces. Since no two runways are alike, the runway surface differs from one runway to another, as does ... runway gradient or slope. [Figure 11-15] Runway surfaces vary widely from one airport to another. The runway surface encountered may be concrete, asphalt, gravel, dirt, or grass. The runway surface for a specific airport is noted in the Chart…
- Chapter 14: Airport Operations › Collision Avoidance › Clearing Procedures
Clearing Procedures The following procedures and considerations are in place to assist pilots in collision avoidance under various situations: • Before takeoff—prior to taxiing onto a runway or landing area in preparation for takeoff, pilots should scan the approach area ... airspace. • Straight and level—during sustained periods of straight-and-level flight, a pilot should execute appropriate clearing procedures at periodic intervals. • Traffic patterns—entries into traffic patterns while descending should be avoided. • Traffic at VOR sites—due to converging…
- Chapter 8: Aviation Instructor Responsibilities and Professionalism › Flight Instructor Responsibilities › Ensuring Learner Skill Set
item included in the applicable ACS/ PTS. The ACS integrates risk management and safety throughout and with supplementary appendix information. PTS lists special emphasis items. Some common items include: 1. Positive aircraft control 2. Procedures for positive ... exchange of flight controls 3. Stall and spin awareness 4. Collision avoidance 5. Wake turbulence and low-level wind turbulence and wind shear avoidance 6. Runway incursion avoidance 7. Controlled flight into terrain (CFIT) 8. Aeronautical decision-making (ADM)/risk…
- 14 CFR Part 141, Appendix J to Part 141—Aircraft Type Rating Course, For Other Than an Airline Transport Pilot Certificate
Airline Transport Pilot Certificate (1) A type rating for an airplane—single-engine course: (i) Preflight preparation; (ii) Preflight procedures; (iii) Takeoff and departure phase; (iv) In-flight maneuvers; (v) Instrument procedures; (vi) Landings and approaches to landings; (vii) Normal ... abnormal procedures; (viii) Emergency procedures; and (ix) Postflight procedures. (2) A type rating for an airplane—multiengine course: (i) Preflight preparation; (ii) Preflight procedures; (iii) Takeoff and departure phase; (iv) In-flight maneuvers; (v) Instrument procedures; (vi) Landings and approaches…