AP.VII.C.S3
SkillMaintain the operating powerplant(s) within acceptable operating limits.
From the FAA library
- Chapter 9: Flight Manuals and Other Documents › Powerplant
Powerplant The Powerplant Limitations portion describes operating limitations on an aircraft’s reciprocating or turbine engine(s). These include limitations for takeoff power, maximum continuous power, and maximum normal operating power, which is the maximum power the engine can produce ... included in this area are the minimum and maximum oil and fuel pressures, oil and fuel grades, and propeller operating limits. [Figure 9-3] All reciprocating-engine powered aircraft must have a revolutions per minute (rpm) indicator for each engine…
- Chapter 15: Airspace › Air Traffic Control and the National Airspace System › Operating Rules and Pilot/Equipment Requirements
Additionally, beginning January 1, 2020, aircraft operating in the Class C airspace described in 14 CFR part 91, section 91.225, must have ADS-B Out equipment installed, which meets the performance requirements of 14 CFR part 91, section 91.227. Class ... pilot may take off or land an aircraft at a satellite airport within a Class D airspace area except in compliance with FAA arrival and departure traffic patterns. A pilot departing from the primary airport or satellite airport with…
- Chapter 9: Flight Manuals and Other Documents › Minimum Equipment Lists (MEL) and Operations With Inoperative Equipment
thorough and systematic means by which a pilot determines if an aircraft is airworthy and in condition for safe operation. POHs and owner/information manuals contain a section devoted to a systematic method of performing a preflight inspection. Minimum Equipment Lists ... Operations With Inoperative Equipment Under 14 CFR, all aircraft instruments and installed equipment are required to be operative prior to each departure. When the FAA adopted the minimum equipment list (MEL) concept for 14 CFR part 91 operations, it allowed…
- Chapter 10: Weight and Balance › Balance, Stability, and Center of Gravity › Stability
same manner as those mentioned for an excess weight condition. It is vital to comply with weight and balance limits established for all aircraft. Operating above the maximum weight limitation compromises the structural integrity of the aircraft and can adversely ... undesirable characteristic. This makes it easy for the pilot to inadvertently overstress an aircraft. Stability and Center of Gravity Limits for the location of the CG are established by the manufacturer. These are the fore and aft limits beyond which…
- 14 CFR § 61.94 Student pilot seeking a sport pilot certificate or a recreational pilot certificate: Operations at airports within, and in airspace located within, Class B, C, and D airspace, or at ai
Student pilot seeking a sport pilot certificate or a recreational pilot certificate: Operations at airports within, and in airspace located within, Class B, C, and D airspace, or at airports with an operational control tower in other airspace ... student pilot seeking a sport pilot certificate or a recreational pilot certificate who wants to obtain privileges to operate in Class B, C, and D airspace, at an airport located in Class B, C, or D airspace, and to, from…
- 14 CFR § 121.434 Operating experience, operating cycles, and consolidation of knowledge and skills.
Operating experience, operating cycles, and consolidation of knowledge and skills. operating flight time for consolidation of knowledge and skills (including operating experience required under paragraph (c) of this section) within 120 days after the satisfactory completion of: (1) Any part ... have qualified and served as pilot in command or second in command on a particular type airplane in operations under this part before August 25, 1995 are not required to complete line operating flight time for consolidation of knowledge…