HI.II.F.K1i

From the FAA library

• Pilot's Handbook of Aeronautical Knowledgep. 8-11
  Chapter 8: Flight Instruments › Electronic Flight Display (EFD)

  Trapped static pressure causes the altimeter to freeze at the altitude where the blockage occurred. In the case of the VSI, a blocked static system produces a continuous zero indication. [Figure 8-11] Some aircraft are equipped with an alternate ... static source in the flight deck. In the case of a blocked static source, opening the alternate static source introduces static pressure from the flight deck into the system. Flight deck static pressure is lower than outside static pressure. Check…

• Aviation Instructor's Handbookp. 9-12
  Chapter 9: Techniques of Flight Instruction › Postflight Evaluation › First Solo Flight

  First Solo Flight During the learner’s first solo flight, the instructor needs to be present to assist in answering questions or resolving any issues that arise during the flight. To ensure the solo flight is a positive, confidence-building ... experience for the learner, the flight instructor needs to consider time of day when scheduling the flight. Time of day is a factor in traffic congestion, possible winds, sun angles, and reflection. If possible, the flight instructor needs access…

• Pilot's Handbook of Aeronautical Knowledgep. 8-11
  Chapter 8: Flight Instruments › Blocked Static System

  Blocked Static System If the static system becomes blocked but the pitot tube remains clear, the ASI continues to operate; however, it is inaccurate. The airspeed indicates lower than the actual airspeed when the aircraft is operated above the altitude ... where the static ports became blocked because the trapped static pressure is higher than normal for that altitude. When operating at a lower altitude, a faster than actual airspeed is displayed due to the relatively low static pressure trapped…

• Aviation Instructor's Handbookp. 9-10
  Chapter 9: Techniques of Flight Instruction › Integrated Flight Instruction › Development of Habit Patterns

  Integrated Flight Instruction Integrated flight instruction is flight instruction during which learners are taught to perform flight maneuvers both by outside visual references and by reference to flight instruments. For this type of instruction to be fully effective ... instrument references should begin the first time each new maneuver is introduced. No distinction in the pilot’s operation of the flight controls is permitted, regardless of whether outside references or instrument indications are used for the performance…

• Aviation Instructor's Handbookp. 9-9
  Chapter 9: Techniques of Flight Instruction › Sterile Flight Deck Rule

  Sterile Flight Deck Rule Commonly known as the “sterile flight deck rule,” Title 14 of the Code of Federal Regulations (14 CFR) part 121, section 121.542 requires airline flight crewmembers to refrain from nonessential activities during critical phases of flight ... defined in the regulation, critical phases of flight are all ground operations involving taxi, takeoff, and landing, and all other flight operations below 10,000 feet except cruise flight. Nonessential activities include such activities as eating, reading a newspaper…

• Pilot's Handbook of Aeronautical Knowledgep. 8-11
  Chapter 8: Flight Instruments › Blocked Pitot System

  Figure 8-10. Blocked pitot system with clear static system. It can be inferred that airspeed indication must be based upon a relationship between these two pressures, and indeed it is. An ASI uses the static pressure as a reference ... pressure and as a result, the ASI’s case is kept at this pressure behind the diaphragm. On the other hand, the dynamic pressure through the pitot tube is connected to a highly sensitive diaphragm within the ASI case. Because…