HI.VII.A.S4
SkillAscend to and maintain recommended hovering altitude, and descend from recommended hovering altitude in headwind, crosswind, and tailwind conditions, without drift.
From the FAA library
- Chapter 9: Basic Flight Maneuvers › Normal Takeoff from a Hover › Technique
Normal Takeoff from a Hover A normal takeoff from a hover is an orderly transition to forward flight and is executed to increase altitude safely and expeditiously. Before initiating a takeoff, the pilot should ensure that the proper checklist ... shaded areas of the height/velocity diagram. Technique Refer to Figure 9-12 (position 1). Bring the helicopter to a hover and perform a hover and systems check, which includes power, balance, and flight controls prior to continuing flight. The power…
- Chapter 9: Basic Flight Maneuvers › Hovering—Sideward Flight › Technique
Exaggerated movement of the cyclic, resulting in erratic movement over the surface. Figure 9-7. To maintain a straight ground track, use two reference points in line and at some distance in front of the helicopter. Failure to use proper ... antitorque pedal control, resulting in excessive heading change. 3. Failure to maintain desired hovering height. 4. Failure to maintain proper rpm. 5. Failure to maintain alignment with direction of travel. Hovering—Sideward Flight Sideward hovering flight may be necessary…
- Chapter 9: Basic Flight Maneuvers › Vertical Takeoff to a Hover › Technique
Helicopters usually hover left side low due to the tail rotor thrust being counteracted by the main rotor tilt. A nose low or high condition is generally caused by loading. Once stabilized, check the engine instruments and note the power ... required to hover. Excessive movement of any flight control requires a change in the other flight controls. For example, if the helicopter drifts to one side while hovering, the pilot naturally moves the cyclic in the opposite direction. When this…
- Chapter 9: Basic Flight Maneuvers › Hovering—Rearward Flight › Technique
over the surface. 2. Failure to use proper antitorque pedal control, resulting in excessive heading change. 3. Failure to maintain desired hovering height. 4. Failure to maintain proper rpm. 5. Failure to make sure the area is clear prior ... starting the maneuver. Hovering—Rearward Flight Rearward hovering flight may be necessary to move the helicopter to a specific area when the situation is such that forward or sideward hovering flight cannot be used. During the maneuver, maintain a constant…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance
deceleration during the landing is identical to the effect on acceleration during the takeoff. The effect of pressure altitude and ambient temperature is to define density altitude and its effect on landing performance. An increase in density altitude increases ... landing speed but does not alter the net retarding force. Thus, the aircraft at altitude lands at the same IAS as at sea level but, because of the reduced density, the TAS is greater. Since the aircraft lands at altitude…
- 14 CFR § 91.179 IFR cruising altitude or flight level.
cruising altitude or flight level. Unless otherwise authorized by ATC, the following rules apply— (a) In controlled airspace. Each person operating an aircraft under IFR in level cruising flight in controlled airspace shall maintain the altitude or flight level assigned ... that aircraft by ATC. However, if the ATC clearance assigns “VFR conditions on-top,” that person shall maintain an altitude or flight level as prescribed by § 91.159. (b) In uncontrolled airspace. Except while in a holding pattern of 2 minutes…