Tutor Platform

HI.VII.D.S5

Skill

Properly use cyclic, collective, and brakes as applicable to control speed while taxiing.

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

Sign in to generate a study note

From the FAA library

  • Chapter 6: Flight Controls › Flight Control Systems › Primary Flight Controls

    Flight Control Systems Flight Controls Aircraft flight control systems consist of primary and secondary systems. The ailerons, elevator (or stabilator), and rudder constitute the primary control system and are required to control an aircraft safely during flight. Wing flaps, leading ... edge devices, spoilers, and trim systems constitute the secondary control system and improve the performance characteristics of the airplane or relieve the pilot of excessive control forces. Primary Flight Controls Aircraft control systems are carefully designed to provide adequate responsiveness…

  • Chapter 9: Techniques of Flight Instruction › Positive Exchange of Flight Controls › Procedure

    Procedure During flight training, there should always be a clear understanding between learners and flight instructors about who has control of the aircraft. The preflight briefing should include procedures for the exchange of flight controls. A positive three-step process ... exchange of flight controls between pilots is a proven procedure and one that is strongly recommended. When an instructor is teaching a maneuver to a learner, the instructor normally demonstrates the maneuver first, then has the learner follow along…

  • Chapter 6: Flight Controls

    addition, in some large and fast aircraft, controls are boosted by hydraulically or electrically actuated systems. In both the fly-by-wire and boosted controls, the feel of the control reaction is fed back to the pilot by simulated means ... Current research at the National Aeronautics and Space Administration (NASA) Dryden Flight Research Center involves Intelligent Flight Control Systems (IFCS). The goal of this project is to develop an adaptive neural network-based flight control system. Applied directly to flight…

  • Chapter 5: Aerodynamics of Flight › Boundary Layer Separation › High Speed Flight Controls

    High Speed Flight Controls On high-speed aircraft, flight controls are divided into primary flight controls and secondary or auxiliary flight controls. The primary flight controls maneuver the aircraft about the pitch, roll, and yaw axes. They include the ailerons ... elevator, and rudder. Secondary or auxiliary flight controls include tabs, leading edge flaps, trailing edge flaps, spoilers, and slats. Spoilers are used on the upper surface of the wing to spoil or reduce lift. High speed aircraft, due to their…

  • Chapter 9: Basic Flight Maneuvers › Taxiing › Air Taxi

    Hover Taxi A hover taxi is used when operating below 25 feet above ground level (AGL). [Figure 9-9] Since hover taxi is just like forward, sideward, or rearward hovering flight, the technique to perform it is not presented here ... Taxi An air taxi is preferred when movements require greater distances within an airport or heliport boundary. [Figure 9-10] In this case, fly to the new location; however, it is expected that the helicopter will remain below 100 feet…

  • Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-18. Taxiing

    Taxiing a. General. Approval must be obtained prior to moving an aircraft or vehicle onto the movement area during the hours an Airport Traffic Control Tower is in operation. 1. Always state your position on the airport when calling ... tower for taxi instructions. 2. The movement area is normally described in local bulletins issued by the airport manager or control tower. These bulletins may be found in FSSs, fixed base operators offices, air carrier offices, and operations offices…