HI.VII.E.K2

From the FAA library

• Helicopter Flying Handbookp. 10-8
  Chapter 10: Advanced Flight Maneuvers › Slope Operations › Technique

  Refer to Figure 10-6. At the termination of the approach, if necessary, move the helicopter slowly toward the slope, being careful not to turn the tail upslope. Position the helicopter across the slope at a stabilized hover headed into ... touches the ground, hesitate momentarily in a level attitude, then apply slight lateral cyclic in the direction of the slope (frame 2). This holds the skid against the slope while the pilot continues lowering the downslope skid with the collective…

• Helicopter Flying Handbookp. 10-7
  Chapter 10: Advanced Flight Maneuvers › Slope Operations

  Slope Operations Prior to conducting any slope operations, be thoroughly familiar with the characteristics of dynamic rollover and mast bumping, which are discussed in Chapter 11, Helicopter Emergencies and Hazards. The approach to a slope is similar to the approach ... other landing area. During slope operations, make allowances for wind, barriers, and forced landing sites in case of engine failure. Since the slope may constitute an obstruction to wind passage, anticipate turbulence and downdrafts. Slope Landing A pilot usually lands…

• Pilot's Handbook of Aeronautical Knowledgep. 5-36
  Chapter 5: Aerodynamics of Flight › Load Factors › Load Factors and Flight Maneuvers

  Spins Load Factors and Flight Maneuvers Critical load factors apply to all flight maneuvers except unaccelerated straight flight where a load factor of 1 G is always present. Certain maneuvers considered in this section are known to involve relatively high ... load factors. Full application of pitch, roll, or yaw controls should be confined to speeds below the maneuvering speed. Avoid rapid and large alternating control inputs, especially in combination with large changes in pitch, roll, or yaw (e.g., large sideslip…

• Pilot's Handbook of Aeronautical Knowledgep. 5-37
  Chapter 5: Aerodynamics of Flight › Load Factors › Vg Diagram

  flight operating strength of an aircraft is presented on a graph whose vertical scale is based on load factor. [Figure 5-55] The diagram is called a Vg diagram—velocity versus G loads or load factor. Each aircraft ... more than +1 G at 64 mph, the wing level stall speed of the aircraft. Since the maximum load factor varies with the square of the airspeed, the maximum positive lift capability of this aircraft…

• Pilot's Handbook of Aeronautical Knowledgep. 5-33
  Chapter 5: Aerodynamics of Flight › Load Factors

  above considerations apply to all loading conditions, whether they be due to gusts, maneuvers, or landings. The gust load factor requirements now in effect are substantially the same as those that have been in existence for years. Hundreds of thousands ... operational hours have proven them adequate for safety. Since the pilot has little control over gust load factors (except to reduce the aircraft’s speed when rough air is encountered), the gust loading requirements are substantially the same for most…