HI.VII.E.R7

From the FAA library

• Helicopter Flying Handbookp. 10-8
  Chapter 10: Advanced Flight Maneuvers › Slope Operations › Technique

  Refer to Figure 10-6. At the termination of the approach, if necessary, move the helicopter slowly toward the slope, being careful not to turn the tail upslope. Position the helicopter across the slope at a stabilized hover headed into ... touches the ground, hesitate momentarily in a level attitude, then apply slight lateral cyclic in the direction of the slope (frame 2). This holds the skid against the slope while the pilot continues lowering the downslope skid with the collective…

• Helicopter Flying Handbookp. 10-7
  Chapter 10: Advanced Flight Maneuvers › Slope Operations

  Slope Operations Prior to conducting any slope operations, be thoroughly familiar with the characteristics of dynamic rollover and mast bumping, which are discussed in Chapter 11, Helicopter Emergencies and Hazards. The approach to a slope is similar to the approach ... other landing area. During slope operations, make allowances for wind, barriers, and forced landing sites in case of engine failure. Since the slope may constitute an obstruction to wind passage, anticipate turbulence and downdrafts. Slope Landing A pilot usually lands…

• Helicopter Flying Handbookp. 5-3
  Chapter 5: Rotorcraft Flight Manual › Operating Limitations (Section 2) › Rotor Limitations

  Altitude Limitations If the rotorcraft has a maximum operating density altitude (see page 7-2), it is indicated in this section of the flight manual. Sometimes the maximum altitude varies based on different gross weights. Rotor Limitations Low rpm does ... produce sufficient lift, and high rpm may cause structural damage, therefore rotor rpm limitations have minimum and maximum values. A green arc depicts the normal operating range with red lines showing the minimum and maximum limits. [Figure 5-3] There…

• Helicopter Flying Handbookp. 5-2
  Chapter 5: Rotorcraft Flight Manual › Operating Limitations (Section 2) › Airspeed Limitations

  Instrument Markings Instrument markings may include, but are not limited to, green, red, and yellow ranges for the safe operation of the aircraft. The green marking indicates a range of continuous operation. The red range indicates the maximum or minimum ... operation allowed while the yellow range indicates a caution or transition area. Airspeed Limitations Airspeed limitations are shown on the airspeed indicator by color coding and on placards or graphs in the aircraft. A red line on the airspeed indicator…

• Helicopter Flying Handbookp. 5-3
  Chapter 5: Rotorcraft Flight Manual › Operating Limitations (Section 2) › Powerplant Limitations

  Powerplant Limitations The powerplant limitations area describes operating limitations on the helicopter’s engine including such items as rpm range, power limitations, operating temperatures, and fuel and oil requirements. Most turbine engines and some reciprocating engines have a maximum power ... maximum continuous power rating. The “maximum power” rating is the maximum power the engine can generate and is usually limited by time. The maximum power range is depicted by a yellow arc on the engine power instruments, with…

• 14 CFR Part 117 — Flight and Duty Limitations and Rest Requirements: Flightcrew MembersOpen
  14 CFR § 117.11 Flight time limitation.

  Flight time limitation. (a) No certificate holder may schedule and no flightcrew member may accept an assignment or continue an assigned flight duty period if the total flight time: (1) Will exceed the limits specified in Table A of this ... part if the operation is conducted with the minimum required flightcrew. (2) Will exceed 13 hours if the operation is conducted with a 3-pilot flightcrew. (3) Will exceed 17 hours if the operation is conducted with a 4-pilot…