HI.XII.B.S4

From the FAA library

• Helicopter Flying Handbookp. 10-2
  Chapter 10: Advanced Flight Maneuvers › Reconnaissance Procedures › High Reconnaissance

  flown so low that a pilot must divide attention between studying the area and avoiding obstructions to flight. A high reconnaissance should be flown at an altitude of 300 to 500 feet above the surface. A general rule to follow ... Always maintain safe altitudes and airspeeds and keep a forced landing area within reach whenever possible. Low Reconnaissance A low reconnaissance is accomplished during the approach to the landing area. When flying the approach, verify what was observed…

• Pilot's Handbook of Aeronautical Knowledgep. 5-49
  Chapter 5: Aerodynamics of Flight › Boundary Layer Separation › High Speed Flight Controls

  High Speed Flight Controls On high-speed aircraft, flight controls are divided into primary flight controls and secondary or auxiliary flight controls. The primary flight controls maneuver the aircraft about the pitch, roll, and yaw axes. They include the ailerons ... flaps, spoilers, and slats. Spoilers are used on the upper surface of the wing to spoil or reduce lift. High speed aircraft, due to their clean low drag design, use spoilers as speed brakes to slow them down. Spoilers…

• Pilot's Handbook of Aeronautical Knowledgep. 12-7
  Chapter 12: Weather Theory › Wind and Currents › Wind Patterns

  Wind Patterns In the Northern Hemisphere, the flow of air from areas of high to low pressure is deflected to the right and produces a clockwise circulation around an area of high pressure. This is known as anticyclonic circulation ... opposite is true of low-pressure areas; the air flows toward a low and is deflected to create a counterclockwise or cyclonic circulation. [Figure 12-10] High-pressure systems are generally areas of dry, descending air. Good weather is typically…

• Pilot's Handbook of Aeronautical Knowledgep. 5-3
  Chapter 5: Aerodynamics of Flight › Thrust

  given airfoil shape) is that lift varies with the AOA and airspeed. Therefore, a large AOA at low airspeeds produces an equal amount of lift at high airspeeds with a low AOA. The speed regimes of flight can be grouped ... three categories: low-speed flight, cruising flight, and high-speed flight. When the airspeed is low, the AOA must be relatively high if the balance between lift and weight is to be maintained. [Figure 5-3] If thrust decreases…

• Pilot's Handbook of Aeronautical Knowledgep. 5-21
  Chapter 5: Aerodynamics of Flight › Effect of Wing Planform

  root to the tip of the wing). In general, tapering causes a decrease in drag (most effective at high speeds) and an increase in lift. There is also a structural benefit due to a saving in weight of the wing ... Most training and general aviation type airplanes are operated at high coefficients of lift, and therefore require comparatively high aspect ratios. Airplanes that are developed to operate at very high speeds demand greater aerodynamic cleanness and greater strength, which require…

• 14 CFR Part 61 — Certification: Pilots, Flight Instructors, and Ground InstructorsOpen
  14 CFR § 61.31 Type rating requirements, additional training, and authorization requirements.

  endorsement in the pilot's logbook from an authorized instructor who certifies the person is proficient to operate a high-performance airplane. (2) The training and endorsement required by paragraph (f)(1) of this section is not required ... person has logged flight time as pilot in command of a high-performance airplane, or in a full flight simulator or flight training device that is representative of a high-performance airplane prior to August…