IL.V.D.K6c
KnowledgeProcedures for:
Radio communications at towered and non-towered airports/heliports/helipads/landing areas
From the FAA library
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-18. Taxiing
Taxiing a. General. Approval must be obtained prior to moving an aircraft or vehicle onto the movement area during the hours an Airport Traffic Control Tower is in operation. 1. Always state your position on the airport when calling ... tower for taxi instructions. 2. The movement area is normally described in local bulletins issued by the airport manager or control tower. These bulletins may be found in FSSs, fixed base operators offices, air carrier offices, and operations offices…
- Chapter 10: Teaching Practical Risk Management during Flight Instruction › Notes on Instructional Risk Management in the Flight Deck › Managing Risk while Teaching Landings
Excessive teaching and coaching on final approach may cause missed radio transmissions from air traffic control or aircraft in the pattern. To avoid this, the instructor should only use concise prompting on approach to landings with the learner. Certain landings ... present unique risks. The instructor teaches the appropriate pre-landing reconnaissance for unfamiliar landing areas or uncontrolled fields. During landings in strong winds, the instructor should have the skill sufficient to deal with the wind conditions. During a short-field…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-21. Exiting the Runway After Landing
Pilots must not exit the landing runway onto another runway unless authorized by ATC. At airports with an operating control tower, pilots should not stop or reverse course on the runway without first obtaining ATC approval. b. Taxi clear ... runway holding position markings. In the absence of ATC instructions, the pilot is expected to taxi clear of the landing runway by taxiing beyond the runway holding position markings associated with the landing runway, even if that requires the aircraft…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-25. Flight Inspection/‘Flight Check’ Aircraft in Terminal Areas
across any runway. This increases the conspicuousness of the aircraft to controllers and other pilots approaching to land, taxiing, or crossing the runway. Pilots should comply with any equipment operating limitations and consider the effects of landing and strobe lights ... vicinity. g. When entering the departure runway for takeoff or to “line up and wait,” all lights, except for landing lights, should be illuminated to make the aircraft conspicuous to ATC and other aircraft on approach. Landing lights should…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-14. Communications
tower controller will consider that pilots of turbine-powered aircraft are ready for takeoff when they reach the runway or warm-up block unless advised otherwise. c. The majority of ground control frequencies are in the 121.6-121.9 MHz bandwidth ... Ground control frequencies are provided to eliminate frequency congestion on the tower (local control) frequency and are limited to communications between the tower and aircraft on the ground and between the tower and utility vehicles on the airport, provide…
- 14 CFR § 61.94 Student pilot seeking a sport pilot certificate or a recreational pilot certificate: Operations at airports within, and in airspace located within, Class B, C, and D airspace, or at ai
Student pilot seeking a sport pilot certificate or a recreational pilot certificate: Operations at airports within, and in airspace located within, Class B, C, and D airspace, or at airports with an operational control tower in other airspace ... recreational pilot certificate who wants to obtain privileges to operate in Class B, C, and D airspace, at an airport located in Class B, C, or D airspace, and to, from, through, or at an airport having an operational control…