IL.V.D.S5

From the FAA library

• Aeronautical Information Manualp. 4-3-30
  Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-25. Flight Inspection/‘Flight Check’ Aircraft in Terminal Areas

  lights should be illuminated when taxiing on or across any runway. This increases the conspicuousness of the aircraft to controllers and other pilots approaching to land, taxiing, or crossing the runway. Pilots should comply with any equipment operating limitations ... consider the effects of landing and strobe lights on other aircraft in their vicinity. g. When entering the departure runway for takeoff or to “line up and wait,” all lights, except for landing lights, should be illuminated to make…

• Aeronautical Information Manualp. 4-3-24
  Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-18. Taxiing

  Taxiing a. General. Approval must be obtained prior to moving an aircraft or vehicle onto the movement area during the hours an Airport Traffic Control Tower is in operation. 1. Always state your position on the airport when calling ... tower for taxi instructions. 2. The movement area is normally described in local bulletins issued by the airport manager or control tower. These bulletins may be found in FSSs, fixed base operators offices, air carrier offices, and operations offices…

• Aeronautical Information Manualp. 4-3-28
  Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-21. Exiting the Runway After Landing

  Pilots must not exit the landing runway onto another runway unless authorized by ATC. At airports with an operating control tower, pilots should not stop or reverse course on the runway without first obtaining ATC approval. b. Taxi clear ... runway unless otherwise directed by ATC. An aircraft is considered clear of the runway when all parts of the aircraft are past the runway edge and there are no restrictions to its continued movement beyond the runway holding position markings…

• Pilot's Handbook of Aeronautical Knowledgep. 6-2
  Chapter 6: Flight Controls › Flight Control Systems › Primary Flight Controls

  Flight Control Systems Flight Controls Aircraft flight control systems consist of primary and secondary systems. The ailerons, elevator (or stabilator), and rudder constitute the primary control system and are required to control an aircraft safely during flight. Wing flaps, leading ... edge devices, spoilers, and trim systems constitute the secondary control system and improve the performance characteristics of the airplane or relieve the pilot of excessive control forces. Primary Flight Controls Aircraft control systems are carefully designed to provide adequate responsiveness…

• Aeronautical Information Manualp. 5-2-1
  Chapter 5. Air Traffic Procedures › Section 2. Departure Procedures › 5-2-1. Pre-taxi Clearance Procedures

  Section 2. Departure Procedures 5-2-1. Pre-taxi Clearance Procedures a. Certain airports have established pre-taxi clearance programs whereby pilots of departing instrument flight rules (IFR) aircraft may elect to receive their IFR clearances before they start taxiing ... takeoff. The following provisions are included in such procedures: 1. Pilot participation is not mandatory. 2. Participating pilots call clearance delivery or ground control not more than 10 minutes before proposed taxi time. 3. IFR clearance (or delay information…

• Instrument Procedures Handbookp. 1-7
  Chapter 1: Departure Procedures › Standardized Taxi Routes

  When exiting the runway, pilots should make sure they are turning with a “lead-off” taxiline onto a taxiway and not onto another active runway. Runway 12 and Taxiway B Aircraft northbound on taxiway B for departure on runway ... taxiway intersection D miss the right turn onto taxiway D and enter runways 12, 7L, and 25R. Runway 16R/34L at Taxiway F Aircraft taxiing to runway 16R from the southwest ramp miss the left turn onto taxiway B, continue eastbound…