IL.VI.C.S6
SkillMaintain situational awareness and proper spacing from other aircraft in the traffic pattern.
From the FAA library
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-3. Traffic Patterns
Traffic Patterns a. It is recommended that aircraft enter the airport traffic pattern at one of the following altitudes listed below. These altitudes should be maintained unless another traffic pattern altitude is published in the Chart Supplement or unless otherwise ... cloud criteria (14 CFR section 91.155). (See FIG 4-3-2 and FIG 4-3-3): 1. Propeller-driven aircraft enter the traffic pattern at 1,000 feet above ground level (AGL). 2. Large and turbine-powered aircraft enter…
- Chapter 14: Airport Operations › Traffic Patterns › Example: Key to Traffic Pattern Operations— Single Runway
Example: Key to Traffic Pattern Operations— Single Runway 1. Enter pattern in level flight, abeam the midpoint of the runway, at pattern altitude. (1,000' AGL is recommended pattern altitude unless otherwise established.) [Figure 14-39] 2. Maintain pattern altitude ... around, continue straight ahead until beyond departure end of runway. [Figure 14-39] 5. If remaining in the traffic pattern, commence turn to crosswind leg beyond the departure end of the runway within 300 feet of pattern altitude. [Figure…
- Chapter 4. Air Traffic Control › Section 3. Airport Operations › 4-3-5. Unexpected Maneuvers in the Airport Traffic Pattern
Unexpected Maneuvers in the Airport Traffic Pattern There have been several incidents in the vicinity of controlled airports that were caused primarily by aircraft executing unexpected maneuvers. ATC service is based upon observed or known traffic and airport conditions. Controllers ... establish the sequence of arriving and departing aircraft by requiring them to adjust flight as necessary to achieve proper spacing. These adjustments can only be based on observed traffic, accurate pilot reports, and anticipated aircraft maneuvers. Pilots are expected…
- Chapter 14: Airport Operations › Traffic Patterns
there is no segmented circle installed at the airport, traffic pattern indicators may be installed on or near the end of the runway.) At most airports and military air bases, traffic pattern altitudes for propeller-driven aircraft generally extend from ... feet to as high as 1,500 feet above ground level (AGL). Pilots can obtain the traffic pattern altitude for an airport from the Chart Supplement U.S. (formerly Airport/Facility Directory). Also, traffic pattern altitudes for military turbojet aircraft sometimes extend…
- Chapter 8: Airport Traffic Patterns › Standard Airport Traffic Patterns
traffic pattern altitude is usually 1,000 feet above the elevation of the airport surface. The use of a common altitude at a given airport is the key factor in minimizing the risk of collisions at airports without operating control ... towers. Aircraft speeds are restrained by 14 CFR part 91, section 91.117. When operating in the traffic pattern at most airports with an operating control tower, aircraft typically fly at airspeeds no greater than 200 knots (230 miles per hour…
- 8 BACKGROUND AND SCOPE › 8.2.1 The FAA does not regulate traffic pattern entry, only traffic pattern flow
does not regulate traffic pattern entry, only traffic pattern flow. This means that when entering the traffic pattern at an airport without an operating control tower, inbound pilots are expected to observe other aircraft already in the pattern ... conform to the traffic pattern in use. If there are no other aircraft present, the pilot should check traffic indicators on the ground and wind indicators to determine which runway and traffic pattern direction to use. For example, an aircraft…