IL.VIII.A.R2e

From the FAA library

• Aeronautical Information Manualp. 5-2-14
  Chapter 5. Air Traffic Procedures › Section 2. Departure Procedures › 5-2-9. Instrument Departure Procedures (DP) - Obstacle Departure Procedures (ODP), Stan…

  Cleared to Johnston Airport, Scott One departure, Jonez transition, Q-OneForty-five. Climb via SID.” NOTE-In Example 3, the aircraft must comply with the Scott One departure lateral path and any published speed and altitude restrictions while climbing ... determines the top altitude must be changed to FL180). The clearance will read: “Cleared to Johnston Airport, Scott One departure, Jonez transition, Q-One Forty-five, Climb via SID except maintain flight level one eight zero.” NOTE-In Example…

• Aeronautical Information Manualp. PCG T-9
  Pilot/Controller Glossary › T

  Upwind Leg- A flight path that begins after departure and continues straight ahead along the extended runway centerline. Upwind leg is an extension of departure and is used when issuing control instructions for separation, spacing or sequencing. b. Crosswind ... flight path at right angles to the landing runway off its upwind end. c. Downwind Leg- A flight path parallel to the landing runway in the direction opposite to landing. The downwind leg normally extends between the crosswind…

• Pilot's Handbook of Aeronautical Knowledgep. 11-12
  Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Runway Surface and Gradient

  Runway Surface and Gradient Runway conditions affect takeoff and landing performance. Typically, performance chart information assumes paved, level, smooth, and dry runway surfaces. Since no two runways are alike, the runway surface differs from one runway to another, as does ... runway gradient or slope. [Figure 11-15] Runway surfaces vary widely from one airport to another. The runway surface encountered may be concrete, asphalt, gravel, dirt, or grass. The runway surface for a specific airport is noted in the Chart…