Tutor Platform

IL.VIII.A.S12

Skill

Maintain directional control and proper wind-drift correction throughout takeoff and climb.

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

Sign in to generate a study note

From the FAA library

  • Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance

    Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…

  • Chapter 6: Flight Controls › Flight Control Systems › Primary Flight Controls

    Flight Control Systems Flight Controls Aircraft flight control systems consist of primary and secondary systems. The ailerons, elevator (or stabilator), and rudder constitute the primary control system and are required to control an aircraft safely during flight. Wing flaps, leading ... edge devices, spoilers, and trim systems constitute the secondary control system and improve the performance characteristics of the airplane or relieve the pilot of excessive control forces. Primary Flight Controls Aircraft control systems are carefully designed to provide adequate responsiveness…

  • Chapter 11: Aircraft Performance › Performance › Climb Performance

    Positive climb performance occurs when an aircraft gains PE by increasing altitude. Two basic factors, or a combination of the two factors, contribute to positive climb performance in most aircraft: 1. The aircraft climbs (gains PE) using excess power above ... that required to maintain level flight, or 2. The aircraft climbs by converting airspeed (KE) to altitude (PE). As an example of factor 1 above, an aircraft with an engine capable of producing 200 horsepower (at a given altitude…

  • Chapter 9: Techniques of Flight Instruction › Positive Exchange of Flight Controls › Procedure

    Procedure During flight training, there should always be a clear understanding between learners and flight instructors about who has control of the aircraft. The preflight briefing should include procedures for the exchange of flight controls. A positive three-step process ... exchange of flight controls between pilots is a proven procedure and one that is strongly recommended. When an instructor is teaching a maneuver to a learner, the instructor normally demonstrates the maneuver first, then has the learner follow along…

  • Chapter 6: Takeoffs and Departure Climbs › Soft/Rough-Field Takeoff and Climb › Initial Climb

    Initial Climb After a positive rate of climb is established, and the airplane has accelerated to VY, the pilot should retract the landing gear and flaps, if equipped. If departing from an airstrip with wet snow or slush ... takeoff surface, the gear should not be retracted immediately so that any wet snow or slush can be air-dried. In the event an obstacle needs to be cleared after a soft-field takeoff, the pilot should perform the climb…

  • Chapter 6: Takeoffs and Departure Climbs › Crosswind Takeoff › Takeoff Roll

    Crosswind Takeoff While it is usually preferable to take off directly into the wind whenever possible or practical, there are many instances when circumstances or judgment indicate otherwise. Therefore, the pilot must be familiar with the principles and techniques involved ... crosswind takeoffs, as well as those for normal takeoffs. A crosswind affects the airplane during takeoff much as it does during taxiing. With this in mind, the pilot should be aware that the technique used for crosswind correction during takeoffs…