IL.VIII.B.K5
KnowledgeTakeoff and climb performance and the height velocity (H/V) diagram.
From the FAA library
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance
Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…
- Chapter 11: Aircraft Performance › Performance › Climb Performance
Positive climb performance occurs when an aircraft gains PE by increasing altitude. Two basic factors, or a combination of the two factors, contribute to positive climb performance in most aircraft: 1. The aircraft climbs (gains PE) using excess power above ... that required to maintain level flight, or 2. The aircraft climbs by converting airspeed (KE) to altitude (PE). As an example of factor 1 above, an aircraft with an engine capable of producing 200 horsepower (at a given altitude…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance
Takeoff and Landing Performance The majority of pilot-caused aircraft accidents occur during the takeoff and landing phase of flight. Because of this fact, the pilot must be familiar with all the variables that influence the takeoff and landing performance ... aircraft and must strive for exacting, professional procedures of operation during these phases of flight. Takeoff and landing performance is a condition of accelerated and decelerated motion. For instance, during takeoff an aircraft starts at zero speed and accelerates…
- Chapter 6: Takeoffs and Departure Climbs › Short-Field Takeoff and Maximum Performance Climb
should reduce AOA to attain normal airspeed before attempting to fly out of the ground effect areas. Short-Field Takeoff and Maximum Performance Climb When performing takeoffs and climbs from fields where the takeoff area is short or the available ... takeoff area is restricted by obstructions, the pilot should operate the airplane at the maximum limit of its takeoff performance capabilities. To depart from such an area safely, the pilot needs to exercise positive and precise control of airplane attitude…
- Chapter 6: Takeoffs and Departure Climbs › Soft/Rough-Field Takeoff and Climb › Initial Climb
Initial Climb After a positive rate of climb is established, and the airplane has accelerated to VY, the pilot should retract the landing gear and flaps, if equipped. If departing from an airstrip with wet snow or slush ... takeoff surface, the gear should not be retracted immediately so that any wet snow or slush can be air-dried. In the event an obstacle needs to be cleared after a soft-field takeoff, the pilot should perform the climb…