IL.VIII.B.R2
Risk managementPowerplant failure during rolling takeoff and climb out.
From the FAA library
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Takeoff Performance
Figure 11-19 illustrates the general effect of wind by the percent change in takeoff or landing distance as a function of the ratio of wind velocity to takeoff or landing speed. The effect of proper takeoff speed is especially ... important when runway lengths and takeoff distances are critical. The takeoff speeds specified in the AFM/POH are generally the minimum safe speeds at which the aircraft can become airborne. Any attempt to take off below the recommended speed means that…
- Chapter 11: Aircraft Performance › Performance › Climb Performance
Positive climb performance occurs when an aircraft gains PE by increasing altitude. Two basic factors, or a combination of the two factors, contribute to positive climb performance in most aircraft: 1. The aircraft climbs (gains PE) using excess power above ... that required to maintain level flight, or 2. The aircraft climbs by converting airspeed (KE) to altitude (PE). As an example of factor 1 above, an aircraft with an engine capable of producing 200 horsepower (at a given altitude…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance
Takeoff and Landing Performance The majority of pilot-caused aircraft accidents occur during the takeoff and landing phase of flight. Because of this fact, the pilot must be familiar with all the variables that influence the takeoff and landing performance ... aircraft and must strive for exacting, professional procedures of operation during these phases of flight. Takeoff and landing performance is a condition of accelerated and decelerated motion. For instance, during takeoff an aircraft starts at zero speed and accelerates…
- Chapter 6: Takeoffs and Departure Climbs › Rejected Takeoff/Engine Failure
Rejected Takeoff/Engine Failure Emergency or abnormal situations can occur during a takeoff…
- Chapter 6: Takeoffs and Departure Climbs › Soft/Rough-Field Takeoff and Climb › Initial Climb
Initial Climb After a positive rate of climb is established, and the airplane has accelerated to VY, the pilot should retract the landing gear and flaps, if equipped. If departing from an airstrip with wet snow or slush ... takeoff surface, the gear should not be retracted immediately so that any wet snow or slush can be air-dried. In the event an obstacle needs to be cleared after a soft-field takeoff, the pilot should perform the climb…
- Chapter 6: Takeoffs and Departure Climbs › Short-Field Takeoff and Maximum Performance Climb › Takeoff Roll
Takeoff Roll Taking off from a short field requires the takeoff to be started from the very beginning of the takeoff area. At this point, the airplane is aligned with the intended takeoff path. If the airplane manufacturer recommends ... flaps, they are extended the proper amount before beginning the takeoff roll. This allows the pilot to devote full attention to the proper technique and the airplane’s performance throughout the takeoff. The pilot should apply takeoff power smoothly…