IL.VIII.D.K5
KnowledgeAircraft configurations for the approach and hover.
From the FAA library
- Chapter 7. Safety of Flight › Section 6. Potential Flight Hazards › 7-6-14. Flying in Flat Light, Brown Out Conditions, and White Out Conditions
following factors will affect the probability and severity of brownout: rotor disk loading, rotor configuration, soil composition, wind, approach speed, and approach angle. 2. The brownout phenomenon causes accidents during helicopter landing and take-off operations in dust, fine dirt ... causes significant flight safety risks from aircraft and ground obstacle collisions, and dynamic rollover due to sloped and uneven terrain. 3. This is a dangerous phenomenon experienced by many helicopters when making landing approaches in dusty environments, whereby sand…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-16. Simultaneous Close Parallel PRM Approaches and Simultaneous Offset Instrument A…
Simultaneous Offset Instrument Approach (SOIA). 1. SOIA is a procedure used to conduct simultaneous approaches to runways spaced less than 3,000 feet, but at least 750 feet apart. The SOIA procedure utilizes a straight-in PRM approach ... runway, and a PRM offset approach with glideslope/glidepath to the adjacent runway. In SOIA operations, aircraft are paired, with the aircraft conducting the straight-in PRM approach always positioned slightly ahead of the aircraft conducting the offset PRM approach…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-3. Approach Control
When radar handoffs are utilized, successive arriving flights may be handed off to approach control with radar separation in lieu of vertical separation. (b) After release to approach control, aircraft are vectored to the final approach course (ILS, RNAV ... Radar vectors and altitude or flight levels will be issued as required for spacing and separating aircraft. Therefore, pilots must not deviate from the headings issued by approach control. Aircraft will normally be informed when it is necessary to vector…
- Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-21. Missed Approach
provided, the pilot should conform to radar vectors when provided by ATC in lieu of the published missed approach procedure. (See FIG 5-4-31.) e. Some locations may have a preplanned alternate missed approach procedure ... event the primary NAVAID used for the missed approach procedure is unavailable. To avoid confusion, the alternate missed approach instructions are not published on the chart. However, the alternate missed approach holding pattern will be depicted on the instrument approach…
- Pilot/Controller Glossary › A
SYSTEM.) APB- (See AUTOMATED PROBLEM DETECTION BOUNDARY.) APD- (See AUTOMATED PROBLEM DETECTION.) APDIA- (See AUTOMATED PROBLEM DETECTION INHIBITED AREA.) APPROACH CLEARANCE- Authorization by ATC for a pilot to conduct an instrument approach. The type of instrument approach for which ... clearance and other pertinent information is provided in the approach clearance when required. (See CLEARED APPROACH.) (See INSTRUMENT APPROACH PROCEDURE.) (Refer to AIM.) (Refer to 14 CFR part 91.) APPROACH CONTROL FACILITY- A terminal ATC facility that provides approach control…
- 14 CFR § 61.87 Solo requirements for student pilots.
requirements for student pilots. (15) Approaches to the landing area; (16) Hovering and hovering turns; and (17) For multiengine powered-lifts, simulated one-engine-inoperative approaches and landings. (i) Maneuvers and procedures for pre-solo flight training in a glider ... flight training for the following maneuvers and procedures: (1) Proper flight preparation procedures, including preflight planning, preparation, aircraft systems, and, if appropriate, powerplant operations; (2) Taxiing or surface operations, including runups, if applicable; (3) Launches, including normal and crosswind…