IL.XIV.A.R4
Risk managementAircraft configuration.
From the FAA library
- Chapter 11: Aircraft Performance › Climb Performance Factors › Range Performance
condition is obtained at maximum lift/ drag ratio (L/DMAX), and it is important to note that for a given aircraft configuration, the L/DMAX occurs at a particular AOA and lift coefficient and is unaffected by weight or altitude. A variation ... cases, it is not always true as there are different variables to every situation. Each aircraft configuration is different, and there is not a rule of thumb that encompasses all of them as to how to achieve the max range…
- Chapter 9: Techniques of Flight Instruction › Use of Distractions
landing, and twenty percent were preceded by engine failure. Preoccupation inside or outside the flight deck while changing aircraft configuration or trim, maneuvering to avoid other traffic, or clearing hazardous obstacles during takeoff and climb could create a potential stall/spin ... inadvertent stall or spin or the possibility of an upset while performing tasks that are secondary to controlling the aircraft. The FAA has established a policy for use of certain distractions on practical tests for pilot certification. The purpose…
- Chapter 8: Flight Instruments › Airspeed Indicator Markings
Lower limit of white arc (VS0)—the stalling speed or the minimum steady flight speed in the landing configuration. In small aircraft, this is the power-off stall speed at the maximum landing weight in the landing configuration (gear ... limit of green arc (VS1)—the stalling speed or the minimum steady flight speed obtained in a specified configuration. For most aircraft, this is the power-off stall speed at the maximum takeoff weight in the clean configuration (gear…
- Chapter 1: Risk Management and Single-Pilot Resource Management › Teaching Decision-Making Skills
developing the stick-and-rudder skills required to execute this operation safely. These include power and airspeed management, aircraft configuration, placement in the pattern, wind correction, determining the proper aim point and sight picture, etc. By emphasizing these points through…
- Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance
When minimum landing distances are considered, braking friction forces predominate during the landing roll and, for the majority of aircraft configurations, braking friction is the main source of deceleration. The minimum landing distance varies in direct proportion to the gross ... effect of wind on landing distance is large and deserves proper consideration when predicting landing distance. Since the aircraft lands at a particular airspeed independent of the wind, the principal effect of wind on landing distance is the change…
- Chapter 7: Aircraft Systems › Flameout › Performance Comparison
used rather than brake horsepower, and net thrust must be used for the turbine-powered engines. In addition, aircraft design configuration and size must be approximately the same. When comparing performance, the following definitions are useful: • Brake horsepower…