Tutor Platform

PA.IV.B.S11

Skill

Execute a timely go-around if the approach cannot be made within the tolerances specified above or for any other condition that may result in an unsafe approach or landing.

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

Sign in to generate a study note

From the FAA library

  • LANDINGS

    LANDINGS Landing a skiplane is easy compared to landing with wheels; however, for off-airport landings, extra precautions are necessary. Be careful in choosing a landing site. Before landing, evaluate the site to be sure a safe departure will ... possible. Upon arriving at a prospective landing site, a pass should be made over the landing area to determine landing direction, and to determine if a safe approach and landing can be completed. A trial landing should be accomplished…

  • Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance

    item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…

  • LANDING › DOWNWIND LANDING

    DOWNWIND LANDING Although downwind landings often require significantly more water area, there are occasions when they are more convenient or even safer than landing into the wind. Sometimes landing upwind would mean a long, slow taxi back along the landing ... dock or mooring area. If winds are less than 5 knots and there is ample room, landing downwind could save taxi time. Unless the winds are light, a downwind landing is seldom necessary. Before deciding to land downwind, the pilot…

  • LANDING › EMERGENCY LANDING

    GO-AROUND Whenever landing conditions are not satisfactory, execute a go-around. Potential conflicts with other aircraft, surface vessels or swimmers in the landing area, recognition of a hazard on the water, wind shear, wake turbulence, water surface conditions, mechanical ... failure, or an unstabilized landing approach are a few of the reasons to discontinue a landing attempt. Climb to a safe altitude while executing the go-around checklist, then evaluate the situation, and make another approach under more…

  • Chapter 9: Approaches and Landings › Crosswind Approach and Landing

    Common Errors Common errors with forward slips to a landing: 1. Incorrect pitch adjustments that result in poor airspeed control. 2. Reacting to erroneous airspeed indications. 3. Using excess power while trying to lose altitude. 4. A slip ... same direction as any crosswind. 5. Poor glidepath control. 6. Late transition to a sideslip during landing with crosswinds. 7. Landing without the longitudinal axis parallel to runway. 8. Landing off the centerline. Crosswind Approach and Landing Most runways…

  • Chapter 9: Approaches and Landings › Emergency Approaches and Landings (Simulated)

    Emergency Approaches and Landings (Simulated) During dual training flights, the instructor should give simulated emergency landings by retarding the throttle and calling “simulated emergency landing.” The objective of these simulated emergency landings is to develop a pilot’s accuracy ... judgment, planning, procedures, and confidence when little or no power is available. A simulated emergency landing may be given with the airplane in any configuration. If the simulated power failure occurs while above best glide speed, the pilot allows…