PA.IV.N.R1

From the FAA library

• Airplane Flying Handbookp. 9-10
  Chapter 9: Approaches and Landings › Go-Arounds (Rejected Landings)

  Arounds (Rejected Landings) A go-around is a normal maneuver that is used when approach and landing parameters deviate from expectations or when it is hazardous to continue. Situations such as air traffic control (ATC) requirements, unexpected appearance of hazards ... overtaking another airplane, wind shear, wake turbulence, mechanical failure, or an unstable approach are all reasons to discontinue a landing approach. Like any other normal maneuver, the go-around should be practiced and perfected. The flight instructor should emphasize early…

• Seaplane, Skiplane, and Float/Ski Equipped Helicopter Operations Handbookp. 7-7
  LANDINGS

  LANDINGS Landing a skiplane is easy compared to landing with wheels; however, for off-airport landings, extra precautions are necessary. Be careful in choosing a landing site. Before landing, evaluate the site to be sure a safe departure will ... possible. Upon arriving at a prospective landing site, a pass should be made over the landing area to determine landing direction, and to determine if a safe approach and landing can be completed. A trial landing should be accomplished…

• Pilot's Handbook of Aeronautical Knowledgep. 11-17
  Chapter 11: Aircraft Performance › Takeoff and Landing Performance › Landing Performance

  item that alters the landing speed or deceleration rate during the landing roll affects the landing distance. The effect of gross weight on landing distance is one of the principal items determining the landing distance. One effect of an increased ... gross weight is that a greater speed is required to support the aircraft at the landing AOA and lift coefficient. For an example of the effect of a change in gross weight, a 21 percent increase in landing weight requires…

• Seaplane, Skiplane, and Float/Ski Equipped Helicopter Operations Handbookp. 6-8
  LANDING › EMERGENCY LANDING

  AROUND Whenever landing conditions are not satisfactory, execute a go-around. Potential conflicts with other aircraft, surface vessels or swimmers in the landing area, recognition of a hazard on the water, wind shear, wake turbulence, water surface conditions, mechanical failure ... unstabilized landing approach are a few of the reasons to discontinue a landing attempt. Climb to a safe altitude while executing the go-around checklist, then evaluate the situation, and make another approach under more favorable conditions. Remember that…

• Seaplane, Skiplane, and Float/Ski Equipped Helicopter Operations Handbookp. 6-5
  LANDING › DOWNWIND LANDING

  DOWNWIND LANDING Although downwind landings often require significantly more water area, there are occasions when they are more convenient or even safer than landing into the wind. Sometimes landing upwind would mean a long, slow taxi back along the landing ... dock or mooring area. If winds are less than 5 knots and there is ample room, landing downwind could save taxi time. Unless the winds are light, a downwind landing is seldom necessary. Before deciding to land downwind, the pilot…

• Airplane Flying Handbookp. 16-20
  Chapter 16: Transition to Jet-Powered Airplanes › Jet Engine Landing › Landing Speeds

  Landing Speeds As in the takeoff planning, there are certain speeds that should be taken into consideration when landing a jet airplane. The speeds are as follows: ⦁ VSO —stall speed in the landing configuration. ⦁ VREF —1.3 times the stall speed ... landing configuration. ⦁ Approach climb—the speed that guarantees adequate performance in a go-around situation with an inoperative engine. ⦁ Landing climb—the speed that guarantees adequate performance in arresting the descent and making a go-around from the final stages…