Tutor Platform

PA.IX.G.S6

Skill

Maintain the manufacturer’s recommended approach airspeed +10/-5 knots, in the landing configuration with a stabilized approach, until landing is assured.

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

Sign in to generate a study note

From the FAA library

  • Chapter 9: Approaches and Landings › Normal Approach and Landing › Final Approach

    drift correction is established and maintained to follow a ground track perpendicular to the extension of the landing runway centerline. This requires that the airplane be angled sufficiently into the wind to prevent drifting farther away from the intended landing ... spot. Figure 9-3. Base leg and final approach. Final Approach After the base-to-final approach turn is completed, the pilot aligns the longitudinal axis of the airplane with the centerline of the runway or landing surface…

  • Chapter 9: Approaches and Landings › Short-Field Approach and Landing

    When safety and conditions permit, a wider-than-normal pattern with a longer final approach may be used. This allows the pilot ample opportunity to adjust and stabilize the descent angle after the airplane is configured and trimmed. A stabilized ... approach is essential. The procedures for landing on a short field or for landing approaches over obstacles as recommended in the AFM/POH should be used. [Figure 9-22 and Figure 9-23] These procedures generally involve a final approach started…

  • Chapter 9: Approaches and Landings › Emergency Approaches and Landings (Simulated)

    Emergency Approaches and Landings (Simulated) During dual training flights, the instructor should give simulated emergency landings by retarding the throttle and calling “simulated emergency landing.” The objective of these simulated emergency landings is to develop a pilot’s accuracy, judgment ... planning, procedures, and confidence when little or no power is available. A simulated emergency landing may be given with the airplane in any configuration. If the simulated power failure occurs while above best glide speed, the pilot allows the airplane…

  • Chapter 9: Approaches and Landings › Crosswind Approach and Landing

    Common Errors Common errors with forward slips to a landing: 1. Incorrect pitch adjustments that result in poor airspeed control. 2. Reacting to erroneous airspeed indications. 3. Using excess power while trying to lose altitude. 4. A slip ... same direction as any crosswind. 5. Poor glidepath control. 6. Late transition to a sideslip during landing with crosswinds. 7. Landing without the longitudinal axis parallel to runway. 8. Landing off the centerline. Crosswind Approach and Landing Most runways…

  • Chapter 9: Approaches and Landings › Power-Off Accuracy Approaches › 180° Power-Off Approach

    Full flaps should be delayed until it is clear that adding them will not cause the landing to be short of the point. The pilot should never try to stretch the glide or retract the flaps to reach the desired ... landing spot. On short final, full attention is given to making a good, safe landing rather than concentrating on the selected landing spot. The approach angle used and final approach airspeed determine the probability of landing on the spot…

  • Chapter 9: Approaches and Landings › Final Approach › Stabilized Approach Concept

    cause a sudden decrease in lift, an excessive sink rate, and an aggravated unstable condition. If the approach is too high or too low, it may not be possible to establish a stabilized approach, and the pilot should execute ... around. Typically, pilots go-around if unable to establish a stabilized approach by 500 ft above airport elevation in visual meteorological conditions (VMC) or 1,000 ft above airport elevation in instrument conditions (IMC). For a typical GA piston aircraft…