Tutor Platform

PA.IX.G.S9

Skill

Maintain directional control and appropriate crosswind correction throughout the approach and landing.

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

Sign in to generate a study note

From the FAA library

  • Chapter 9: Approaches and Landings › Crosswind Approach and Landing

    Common Errors Common errors with forward slips to a landing: 1. Incorrect pitch adjustments that result in poor airspeed control. 2. Reacting to erroneous airspeed indications. 3. Using excess power while trying to lose altitude. 4. A slip ... same direction as any crosswind. 5. Poor glidepath control. 6. Late transition to a sideslip during landing with crosswinds. 7. Landing without the longitudinal axis parallel to runway. 8. Landing off the centerline. Crosswind Approach and Landing Most runways…

  • Chapter 9: Approaches and Landings › Normal Approach and Landing › Final Approach

    drift correction is established and maintained to follow a ground track perpendicular to the extension of the landing runway centerline. This requires that the airplane be angled sufficiently into the wind to prevent drifting farther away from the intended landing ... spot. Figure 9-3. Base leg and final approach. Final Approach After the base-to-final approach turn is completed, the pilot aligns the longitudinal axis of the airplane with the centerline of the runway or landing surface…

  • Chapter 9: Approaches and Landings › Crosswind Approach and Landing › Crosswind Final Approach

    Crosswind Final Approach When using the crab method, the pilot makes a coordinated turn to establish a heading (crab) toward the wind. The selected heading should align the airplane’s wings-level ground track with the centerline of the runway ... pilot makes small heading corrections, if needed, to maintain alignment with the runway. [Figure 9-15] The appropriate crab angle is maintained until just prior to touchdown, when the pilot uses rudder control to align the longitudinal axis…

  • Chapter 9: Approaches and Landings › Turbulent Air Approach and Landing

    Attempted landing in crosswinds that exceed the airplane’s maximum demonstrated crosswind component. 2. Undershooting or overshooting the turn from base leg to final approach. 3. Inadequate compensation for wind drift on final approach. 4. Unstable approach. 5. Excessive sink ... axis aligned with the runway. 7. Touching down while drifting. 8. Excessive airspeed on touchdown. 9. Failure to apply appropriate flight control inputs during rollout. 10. Failure to maintain direction control on rollout. 11. Excessive braking. 12. Loss of aircraft…

  • Chapter 9: Approaches and Landings › Emergency Approaches and Landings (Simulated)

    Emergency Approaches and Landings (Simulated) During dual training flights, the instructor should give simulated emergency landings by retarding the throttle and calling “simulated emergency landing.” The objective of these simulated emergency landings is to develop a pilot’s accuracy, judgment ... planning, procedures, and confidence when little or no power is available. A simulated emergency landing may be given with the airplane in any configuration. If the simulated power failure occurs while above best glide speed, the pilot allows the airplane…

  • Chapter 9: Approaches and Landings › Faulty Approaches and Landings › Low Final Approach

    Faulty Approaches and Landings Landing involves many precise, time-sensitive, and sequential control inputs. When corrected early, small errors are often not noticeable. On the other hand, uncorrected errors may place the airplane and occupants in an undesirable state. Since ... pilot training normally includes exposure to landing deviations and their appropriate remedies, this section covers several common landing imperfections. Low Final Approach When the base leg is too low, insufficient power is used, landing flaps are extended prematurely…