Private Pilot for Airplane Category › VII. Slow Flight and Stalls › Task C. Power-On Stalls

PA.VII.C.R3

Risk management

Stall warning(s) during normal operations.

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Airplane Flying Handbook p. 5-9
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Slow Flight
Slow Flight Flying at reduced airspeeds is normal in the takeoff/departure and approach/landing phases of flight. While pilots typically perform these operations at low airspeeds and close to the ground, pilots learn to maneuver an airplane in slow flight ... further increase in angle of attack, increase in load factor, or reduction in power, will result in a stall warning (e.g., aircraft buffet, stall horn, etc.), and pilots should react to and correct for any stall indication. Note that stall…
Airplane Flying Handbook p. 13-9
Chapter 13: Transition to Multiengine Airplanes › Operation of Systems › Anti-Icing/Deicing Equipment
On some fuel-injected engines, an alternate air source is automatically activated…
Airplane Flying Handbook p. 5-12
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Stall Recognition
Indications of a full stall are typically that an uncommanded nose down pitch cannot be readily arrested, and may be accompanied by an uncommanded rolling motion. For airplanes equipped with stick pushers, their activation is also an indicator ... full stall. Although it depends on the degree to which a stall has progressed, some loss of altitude is expected during recovery. The longer it takes for the pilot to recognize an impending stall, the more likely it is that…
Stall and Spin Awareness Training p. 11
CHAPTER 2. FLIGHT TRAINING: STALLS › 200. STALL TRAINING › f. Stalls During Go-Arounds
Cross Controlled Stalls in Gliding Turns. Perform stalls in gliding turns to simulate turns from base to final. Perform the stalls from a properly coordinated turn, a slipping turn, and a skidding turn. Explain the difference between slipping and skidding ... turns. Explain the ball indicator position in each turn and the aircraft behavior in each of the stalls. e. Power-Off (Approach-To-Landing) Stalls (1) Have the student perform a full-flap, gear-extended, power-off stall with…
Airplane Flying Handbook p. 5-20
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls › Accelerated Stalls
increased lift also increases drag, which may cause the airspeed to decrease. The pilot should know the published stall speed for 45° of bank, flaps up, before performing the maneuver. This speed is typically published in the AFM. An airplane ... typically stalls during a level, coordinated turn similar to the way it does in wings-level flight, except that the stall buffet can be sharper. If the turn is coordinated at the time of the stall, the airplane’s nose…
Airplane Flying Handbook p. 5-12
Chapter 5: Maintaining Aircraft Control: Upset Prevention and Recovery Training › Stalls
Stalls A stall is an aerodynamic condition which occurs when smooth airflow over the airplane’s wings is disrupted, resulting in loss of lift. Specifically, a stall occurs when the AOA—the angle between the chord line of the wing ... attitude, and at any power setting. [Figure 5-8] Figure 5-8. Critical angle of attack and stall. For these reasons, it is important to understand factors and situations that can lead to a stall, and develop proficiency in stall…