PA.VIII.B.S3
SkillLevel off at the assigned altitude and maintain altitude ±200 feet, heading ±20°, and airspeed ±10 knots.
From the FAA library
- Chapter 8: Helicopter Attitude Instrument Flying › Straight Descents (Constant Airspeed and Constant Rate) › Level Off
Level Off The level off from a constant airspeed descent may be made at descending airspeed or at cruise airspeed, if this is higher than descending airspeed. As in a climb level off, the amount of lead depends ... rate of descent and control technique. For a level off at descending airspeed, the lead should be approximately 10 percent of the vertical speed. At the lead altitude, simultaneously increase power to the setting necessary to maintain descending airspeed…
- Chapter 4: Energy Management: Mastering Altitude and Airspeed Control › Viewing the Airplane as an Energy System › A Frame of Reference for Managing Energy State
example, if the pilot decides to put all the surplus energy into altitude, the airplane can climb at a constant airspeed. [Figure 4-1A] If the pilot opts to place all the surplus energy into airspeed, the airplane ... accelerate while maintaining altitude. [Figure 4-1B] When drag exceeds thrust, (T – D < 0), the airplane's total mechanical energy decreases. The pilot has two sources of stored energy to tap into. For example, the pilot may choose…
- Chapter 7, Section I: Airplane Basic Flight Maneuvers › Straight-and-Level Flight › Turn-and-Slip Indicator (Needle and Ball)
forces of gravity, drag, and inertia to determine airplane performance. Power control must be related to its effect on altitude and airspeed, since any change in power setting results in a change in the airspeed or the altitude ... airplane. At any given airspeed, the power setting determines whether the airplane is in level flight, in a climb, or in a descent. If the power is increased in straight-and-level flight and the airspeed held constant, the airplane…
- Chapter 8: Helicopter Attitude Instrument Flying › Straight Climbs (Constant Airspeed and Constant Rate) › Level Off
Level Off The level off from a constant airspeed climb must be started before reaching the desired altitude. Although the amount of lead varies with the type of helicopter being flown and pilot technique, the most important factor is vertical ... vertical velocity as the lead point. For example, if the rate of climb is 500 fpm, initiate the level off approximately 50 feet before the desired altitude. When the proper lead altitude is reached, the altimeter becomes primary for pitch…
- Chapter 8: Helicopter Attitude Instrument Flying › Turn Indicator › Power Control During Straight-and-Level Flight
with counter-rotating rotors. To counteract the yawing tendency of the helicopter, apply pedal trim during power changes. To maintain a constant altitude and airspeed in level flight, coordinate pitch attitude and power control. The relationship between altitude and airspeed ... determines the need for a change in power and/or pitch attitude. If the altitude is constant and the airspeed is high or low, change the power to obtain the desired airspeed. During the change in power, make an accurate interpretation…
- Chapter 11: Aircraft Performance › Performance › Climb Performance
Positive climb performance occurs when an aircraft gains PE by increasing altitude. Two basic factors, or a combination of the two factors, contribute to positive climb performance in most aircraft: 1. The aircraft climbs (gains PE) using excess power above ... that required to maintain level flight, or 2. The aircraft climbs by converting airspeed (KE) to altitude (PE). As an example of factor 1 above, an aircraft with an engine capable of producing 200 horsepower (at a given altitude…