PH.V.B.K2

From the FAA library

• Aeronautical Information Manualp. 5-4-49
  Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-16. Simultaneous Close Parallel PRM Approaches and Simultaneous Offset Instrument A…

  Simultaneous Offset Instrument Approach (SOIA). 1. SOIA is a procedure used to conduct simultaneous approaches to runways spaced less than 3,000 feet, but at least 750 feet apart. The SOIA procedure utilizes a straight-in PRM approach ... runway, and a PRM offset approach with glideslope/glidepath to the adjacent runway. In SOIA operations, aircraft are paired, with the aircraft conducting the straight-in PRM approach always positioned slightly ahead of the aircraft conducting the offset PRM approach…

• Aeronautical Information Manualp. 5-4-59
  Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-21. Missed Approach

  provided, the pilot should conform to radar vectors when provided by ATC in lieu of the published missed approach procedure. (See FIG 5-4-31.) e. Some locations may have a preplanned alternate missed approach procedure ... event the primary NAVAID used for the missed approach procedure is unavailable. To avoid confusion, the alternate missed approach instructions are not published on the chart. However, the alternate missed approach holding pattern will be depicted on the instrument approach…

• Aeronautical Information Manualp. 5-4-4
  Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-3. Approach Control

  When radar handoffs are utilized, successive arriving flights may be handed off to approach control with radar separation in lieu of vertical separation. (b) After release to approach control, aircraft are vectored to the final approach course (ILS, RNAV ... issued as required for spacing and separating aircraft. Therefore, pilots must not deviate from the headings issued by approach control. Aircraft will normally be informed when it is necessary to vector across the final approach course for spacing or other…

• Aeronautical Information Manualp. PCG F-2
  Pilot/Controller Glossary › F

  FINAL APPROACH COURSE.) (See FINAL APPROACH FIX.) (See FINAL APPROACH POINT.) (See SEGMENTS OF AN INSTRUMENT APPROACH PROCEDURE.) (See ICAO term FINAL APPROACH.) FINAL APPROACH POINT- The point, applicable only to a nonprecision approach with no depicted FAF (such ... airport VOR), where the aircraft is established inbound on the final approach course from the procedure turn and where the final approach descent may be commenced. The FAP serves as the FAF and identifies the beginning of the final approach…

• Aeronautical Information Manualp. PCG A-14
  Pilot/Controller Glossary › A

  gate will be established along the final approach course 1 mile from the final approach fix on the side away from the airport and will be no closer than 5 miles from the landing threshold. APPROACH/DEPARTURE HOLD AREA- The locations ... taxiways in the approach or departure areas of a runway designated to protect landing or departing aircraft. These locations are identified by signs and markings. APPROACH LIGHT SYSTEM- (See AIRPORT LIGHTING.) APPROACH RUNWAY VERIFICATION- A STARS functionality that provides audible…

• Airplane Flying Handbookp. 9-15
  Chapter 9: Approaches and Landings › Crosswind Approach and Landing › Crosswind Final Approach

  establish a heading (crab) toward the wind. The selected heading should align the airplane’s wings-level ground track with the centerline of the runway. The pilot makes small heading corrections, if needed, to maintain alignment with the runway. [Figure ... final approach, round out, touchdown, and after-landing roll. This prevents the airplane from touching down in a sideward motion and imposing damaging side loads on the landing gear. When first experienced, it may seem odd to land while holding…