PH.V.B.S8

From the FAA library

• Aeronautical Information Manualp. 4-4-9
  Chapter 4. Air Traffic Control › Section 4. ATC Clearances and Aircraft Separation › 4-4-12. Speed Adjustments

  determines (before an approach clearance is issued) that it is no longer necessary to apply speed adjustment procedures, they will: 1. Advise the pilot to “resume normal speed.” Normal speed is used to terminate ATC assigned speed adjustments on segments ... where no published speed restrictions apply. It does not cancel published restrictions on upcoming procedures. This does not relieve the pilot of those speed restrictions which are applicable to 14 CFR section 91.117. EXAMPLE- (An aircraft is flying…

• Aeronautical Information Manualp. 5-5-5
  Chapter 5. Air Traffic Procedures › Section 5. Pilot/Controller Roles and Responsibilities › 5-5-9. Speed Adjustments

  When complying with speed adjustment assignments, maintains an indicated airspeed within plus or minus 10 knots or 0.02 Mach number of the specified speed. b. Controller. 1. Assigns speed adjustments to aircraft when necessary but not as a substitute ... vectoring technique. 2. Adheres to the restrictions published in FAA Order JO 7110.65, Air Traffic Control, as to when speed adjustment procedures may be applied. 3. Avoids speed adjustments requiring alternate decreases and increases. 4. Assigns speed adjustments…

• Aeronautical Information Manualp. 10-1-3
  Chapter 10. Helicopter Operations › Section 1. Helicopter IFR Operations › 10-1-2. Helicopter Instrument Approaches

  final and missed approach segment speeds must be limited to no more than 70 KIAS unless otherwise charted. Military RNAV Copter IAPs are limited to no more than 90 KIAS throughout the procedure. Use the published minima; no reductions allowed ... NOTE-Obstruction clearance surfaces are based on the aircraft speed identified on the approach chart and have been designed on RNAV approaches for 70 knots unless otherwise indicated. If the helicopter is flown at higher speeds, it may fly outside…

• Aeronautical Information Manualp. 5-4-31
  Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-7. Instrument Approach Procedures

  Pilots must carefully plan the initiation of all turns to ensure that the aircraft remains within the circling approach protected area. 4. Pilot technique. Pilots frequently have many options with regard to flightpath when conducting circling approaches. Sound planning ... flown should be carefully considered using current weather and terrain information to ensure that the aircraft remains within the circling approach protected area. d. It is important to remember that 14 CFR section 91.175(c) requires that “where a DA/DH…

• Airplane Flying Handbookp. 9-28
  Chapter 9: Approaches and Landings › Emergency Approaches and Landings (Simulated)

  given with the airplane in any configuration. If the simulated power failure occurs while above best glide speed, the pilot allows the airplane to slow (or may even bleed off speed by climbing) until reaching best glide speed. When reaching ... that speed, the nose can be lowered and the airplane trimmed to maintain that speed. If the failure occurs at or below best glide speed, the nose should be lowered immediately to maintain or accelerate to best glide speed…