Flight Instructor – Instrument Rating Powered-Lift › V. Air Traffic Control (ATC) Clearances and Procedures › Task B. Holding Procedures

PI.V.B.S7

Skill

Use a multi-function display (MFD) and other graphical navigation displays, if installed, to monitor position in relation to the desired flightpath during holding.

Practice questions Ask the tutor

Study note

Get a short, cited explanation of this element written from the FAA handbooks: the core idea, the numbers that matter, common test traps, and a quick self-check.

From the FAA library

Aeronautical Information Manual p. 2-3-14
Chapter 2. Aeronautical Lighting and Other Airport Visual Aids › Section 3. Airport Marking Aids and Signs › 2-3-5. Holding Position Markings
Otherwise, pilots are authorized to use the entire landing length of the runway and disregard the holding position markings. 3. Holding Position Markings on Taxiways Located in Runway Approach Areas. These markings are used at some airports where ... necessary to hold an aircraft on a taxiway located in the approach or departure area of a runway so that the aircraft does not interfere with the operations on that runway. This marking is collocated with the runway approach/departure area…
Aeronautical Information Manual p. 5-3-28
Chapter 5. Air Traffic Procedures › Section 3. En Route Procedures › 5-3-8. Holding
still apply. (c) The following phraseology may be used by an ATCS to advise a pilot of the maximum holding airspeed for a holding pattern airspace area. PHRASEOLOGY- (AIRCRAFT IDENTIFICATION) (holding instructions, when needed) MAXIMUM HOLDING AIRSPEED IS (speed ... knots). FIG 5-3-4 Holding Pattern Entry Procedures 3. Entry Procedures. Holding protected airspace is designed based in part on pilot compliance with the three recommended holding pattern entry procedures discussed below. Deviations from these recommendations, coupled with excessive…
Aeronautical Information Manual p. 5-4-29
Chapter 5. Air Traffic Procedures › Section 4. Arrival Procedures › 5-4-6. Approach Clearance
Arrival Holding. Some approach charts have an arrival holding pattern depicted at an IAF or at a feeder fix located along an airway. The arrival hold is depicted using a “thin line” since it is not always a mandatory part ... instrument procedure. (a) Arrival holding is charted where holding is frequently required prior to starting the approach procedure so that detailed holding instructions are not required. The arrival holding pattern is not authorized unless assigned by ATC. Holding…